PRESS BRAKE PEDAL – DELAYED START-UP. Fiat 500C ABARTH

603_95_XXX ABARTH 500C GB 1ed 10/03/14 10.31 Pagina 21

PRESS BRAKE PEDAL –

DELAYED START-UP

The display shows these messages alternately and in sequence together with an acoustic signal when the system does not recognise the brake pedal as operational during a starting attempt.

In this situation, keep the key on

AVV

for at least 7 seconds with the brake pressed.

The engine will start. The system will be in recovery mode (maximum speed permitted: 3 rd

)

IMPORTANT If start-up is requested with the gearbox faulty, carry out the “Delayed start-up” procedure (see associated messages): turn the key to the

AVV

position for at least 7 seconds with the brake depressed and the engine will start. The system will remain in recovery mode (highest gear permitted 3 rd

, Automatic mode not available). If the engine does not start, contact an

Abarth Dealership

.

IMPORTANT The messages are only displayed if the engine is started with a gear other than neutral (

N

) engaged.

Contact an Abarth Dealership if the messages remain in the display.

GEAR NOT AVAILABLE

This message appears in the display together with an acoustic signal in the following cases:

❒ when it is not possible to change gear due to a fault in the system; or

❒ when, due to a fault in the system, it is only possible to engage 1 st

, 2 nd

, 3 rd or reverse (

R

).

PRESS BRAKE AND REPEAT

MANOEUVRE

The message appears in the display accompanied, in some cases, by an acoustic signal for safety reasons if you attempt to change gear without previously pressing the brake pedal.

Contact an Abarth Dealership if the message remains in the display.

Contact an Abarth Dealership if the message remains in the display.

MANOEUVRE NOT PERMITTED

The message appears in the display together with an acoustic signal when the system will not accept a gear change via the control lever because certain conditions required for acceptance of the gear change are not met.

PLACE GEAR LEVER

IN N (neutral)

This message appears in the display together with a warning acoustic signal when the system asks the driver to perform the manoeuvre.

When the gearbox is changed to (

N

) the message in the display should go off.

Contact an Abarth Dealership if the message remains in the display.

21