Using your dash cam in a vehicle. Mio MiVue J85, MiVue J80 Series, MiVue J80 serie, MiVue J60, MiVue J60 Series

Note: The video resolution of the dash cam will be restored to the default setting automatically while the dash cam is connected to your smartphone. Once the two devices are disconnected, the video resolution will be changed back to its current setting automatically.

Updating your dash cam

Occasionally, MiTAC may offer you various software updates (including the device firmware, safety camera data and audio data). You can upgrade the data via OTA updates of the MiVue Pro app. When the new data is available, you will be asked to upgrade the data when you open the app. Follow the on-screen instructions to complete the update.

Using your dash cam in a vehicle

Precautions and notices

l

Do not operate the device while driving. Using this product does not change the requirement for a driver to take full responsibility for his or her behavior. This responsibility includes observing all traffic rules and regulations in order to avoid accidents, personal injury or property damage.

l

A window mount is needed when using the dash cam in a car. Make sure that you place the dash cam in an appropriate place, so as not to obstruct the driver’s view or deployment of airbags.

l

Make sure that no object is blocking the camera lens and no reflective material is placed near the lens. Please keep the lens clean.

l

If the car’s windscreen is tinted with a coating, it may impact the recording quality.

l

To ensure the highest quality recordings, you are advised to place the dash cam near the rear view mirror.

l

Select an appropriate location for mounting the device in a vehicle. Never place the device where the driver’s field of vision is blocked.

7

l

If the car’s windscreen is tinted with a reflective coating, it may be athermic and impact the GPS reception. In this instance, please mount your device where there is a “clear area.” l

The system will automatically calibrate the G sensor of the device during start-up.

To avoid G sensor malfunction, always turn the device on AFTER you mount it in the vehicle properly.

Mounting the dash cam

1. Make sure that your car is parked on level ground.

1 2 l l

Note:

Before sticking the mounting pad, clean the windscreen with rubbing alcohol.

If the adhesion of the adhesive tape does not perform well, replace the tape with a new one.

2. Connect the car charger to the cigarette lighter. Route the cable through the top ceiling and the A-pillar so that it does not interfere with driving. Make sure that the cable installation does not interfere with the vehicle's airbags or other safety features.

8