ENTERING DIMENSIONS. Calculated Industries 4050 v3.1, Construction Master 5, 4050, Construction Master III

ENTERING DIMENSIONS

Linear Dimensions

When entering Feet-Inch values, enter dimensions from largest to smallest —

Feet before Inches, Inches before

Fractions. Enter Fractions by entering the numerator (top number), pressing /

(Fraction Bar key) and then the denominator (bottom number).

Note: If a denominator is not entered, the fractional setting value is used.

Examples of how linear dimensions are entered (press o after each entry):

DIMENSION KEYSTROKES

5 Yards 5 y

5 Feet 1-1/2 Inch 5 f 1 i 1 / 2

17.5 Meters 1 7 • 5 m

Square and Cubic Dimensions

Examples of how Square and Cubic dimensions are entered (press o after each entry):

DIMENSION KEYSTROKES

5 Cubic Yards 5 y y y

130 Square Feet 1 3 0 f f

33 Square Meters 3 3 m m

P

OCKET

R

EFERENCE

G

UIDE

— 13