advertisement
SN29402761A_TX-NR575E_BAS_En_171107.book 26 ページ ２０１７年１１月６日 月曜日 午前１１時２９分
> Before Start > Part Names > Install > Initial Setup > Playback
USB Storage Device
1 2 3 4
INPUT
TV
26
Basic Operations
You can play music files stored on a USB storage device.
Perform the following procedure when the unit is on.
1. Switch the input on the TV to that assigned to the unit.
2. Plug your USB storage device with the music files into the USB port of this unit’s rear panel.
3. Press NET (a) on the remote controller to display the network service list screen.
4. With the cursors on the remote controller, select "USB", and then press
ENTER (b).
0 If the "USB" indicator flashes on the display, check whether the USB storage device is plugged in properly.
0 Do not unplug the USB storage device while "Connecting···" is appeared on the display. This may cause data corruption or malfunction.
5. Press ENTER on the remote controller again in the next screen. The list of folders and music files on the USB storage device are displayed. Select the folder with the cursors and press ENTER to confirm your selection.
6. With the cursors on the remote controller, select the music file, and then press ENTER to start playback.
0 To return to the previous screen, press
(c).
0 The USB port of this unit conforms with the USB 2.0 standard. The transfer speed may be insufficient for some content you play, which may cause some interruption in sound.
0 Operation cannot be guaranteed for all
USB storage devices.
0 This unit can use USB storage devices that comply with the USB mass storage device class standard. The unit is also compatible with USB storage devices using the FAT16 or FAT32 file system formats.
a b c
advertisement