advertisement
XH1137 – DSE ADSL PCI Modem
7.6 Windows NT4.0 users
7.6.1 Installation for RFC1483/1577
1. On your desktop, double-click My
Computer , and then double-click
Control Panel .
2. In the Control Panel window, double-click the Network icon. The
Network window appears. Select the Adapters tab and then click
Add .
3. The Select Network adapter window appears. Click Have Disk .
4. Insert ADSL Driver CD-ROM into your CD drive.
5. Navigate to the Driver\WinNt40\Lan folder on your CD-ROM. Click OK .
24
6. Find the Conexant Access Runner
PCI ADSL LAN adapter. Click OK .
7. The Network window will appear.
Click the Adapters tab to verify that the Conexant AccessRunner
PCI ADSL LAN adapter had been found. Click on the Protocols tab and verify that the ADSL
Management and Monitor
Interface is present. Click Close .
8. Click Yes .
9. The Microsoft TCP/IP Properties window appears. Enter in the IP
Address , Subnet Mask and Default
Gateway supplied by your ADSL service provider. Click OK .
25
XH1137 – DSE ADSL PCI Modem
10. Enter your host name into Host box, and enter your domain name into Domain box. Enter DNS number into DNS Service Search
Order box and click Add . If you have more than one DNS numbers, repeat this step. After setting all the necessary TCP/IP properties, click OK .
10. You may be asked to restart your computer, click Yes.
After your computer restarts, proceed to the
“Network
Settings”
section and follow the instructions for your operating system.
26
advertisement
Related manuals
advertisement
Table of contents
- 5 INTRODUCTION
- 5 INTERNET SECURITY
- 6 ADSL SERVICE
- 7 FEATURES & SPECIFICATIONS
- 8 TELCO CONNECTION SETTINGS
- 11 HARDWARE INSTALLATION
- 12 Filter Installation Rules
- 16 SOFTWARE INSTALLATION
- 25 7.6.1 Installation for RFC
- 28 7.6.2 Installation for RFC
- 31 NETWORKING SETTINGS
- 31 Configuring RFC
- 34 8.1.3 Configuring RFC
- 35 2000 & XP
- 35 Configuring RFC
- 37 8.2.3 Configuring RFC
- 38 Configuring RFC
- 45 SUPPORT
- 46 GLOSSARY OF TERMS