advertisement
RADIUS Attributes
Login-Service (15)
Specifies the terminal service protocol used for a login connection.
Usage: This attribute is used only when Service-Type (6) is Login [1].
Terminal service to the specified host is started immediately after the user dials in.
Valid values are:
• Telnet [0]
• Rlogin [1]
• LAT [4]
If Service-Type (6) is Login [1] and this attribute is omitted, the RAC places the user at the CLI.
Multiple Instances Allowed: No.
Dependencies: The RAC ignores this attribute if Service-Type (6) is anything other than Login [1]. The attribute value is handled as follows:
• If the value is Telnet [0] or Rlogin [1], the Login-IP-Host (14) attribute must be specified. If it is not, the RAC prompts the user for a target host.
• If the value is LAT [4], the Login-LAT-Node (35) attribute must be specified. If it is not, the RAC prompts the user for a target host.
RADIUS Attributes Reference 15
advertisement
Related manuals
advertisement
Table of contents
- 18 RADIUS Authentication Attributes
- 18 User-Name (1)
- 18 User-Password (2)
- 19 CHAP-Password (3)
- 19 NAS-IP-Address (4)
- 20 NAS-Port (5)
- 22 Service-Type (6)
- 25 Framed-Protocol (7)
- 26 Framed-IP-Address (8)
- 27 Framed-IP-Netmask (9)
- 27 Framed-Routing (10)
- 28 Filter-Id (11)
- 29 Framed-MTU (12)
- 29 Framed-Compression (13)
- 30 Login-IP-Host (14)
- 31 Login-Service (15)
- 32 Login-TCP-Port (16)
- 32 Unassigned (17)
- 32 Reply-Message (18)
- 33 Callback-Number (19)
- 33 Callback-Id (20)
- 34 Unassigned (21)
- 34 Framed-Route (22)
- 35 Framed-IPX-Network (23)
- 35 State (24)
- 35 Class (25)
- 36 Vendor-Specific (26)
- 36 Session-Timeout (27)
- 37 Idle-Timeout (28)
- 37 Termination-Action (29)
- 38 Called-Station-Id (30)
- 38 Calling-Station-Id (31)
- 38 NAS-Identifier (32)
- 39 Proxy-State (33)
- 39 Login-LAT-Service (34)
- 40 Login-LAT-Node (35)
- 40 Framed-AppleTalk-Link (37)
- 40 Framed-AppleTalk-Network (38)
- 41 Framed-Appletalk-Zone (39)
- 41 CHAP-Challenge (40)
- 41 NAS-Port-Type (41)
- 42 Port-Limit (42)
- 42 Login-LAT-Port (43)
- 43 RADIUS Accounting Attributes
- 43 Acct-Status-Type (40)
- 45 Acct-Delay-Time (41)
- 45 Acct-Input-Octets (42)
- 45 Acct-Output-Octets (43)
- 46 Acct-Session-Id (44)
- 46 Acct-Authentic (45)
- 46 Acct-Session-Time (46)
- 47 Acct-Input-Packets (47)
- 47 Acct-Output-Packets (48)
- 48 Acct-Terminate-Cause (49)
- 49 Acct-Multi-Session-Id (50)
- 49 Acct-Link-Count (51)
- 50 Bay Networks Vendor-Specific Attributes
- 50 Annex-Filter (VSA Bay Networks 28)
- 51 Annex-CLI-Command (VSA Bay Networks 29)
- 51 Annex-CLI-Filter (VSA Bay Networks 30)
- 52 Annex-Host-Restrict (VSA Bay Networks 31)
- 53 Annex-Host-Allow (VSA Bay Networks 32)
- 53 Annex-Product-Name (VSA Bay Networks 33)
- 54 Annex-SW-Version (VSA Bay Networks 34)
- 54 Annex-Local-IP-Address (VSA Bay Networks 35)
- 55 Annex-Tunnel-Type (VSA Bay Networks 36)
- 55 (VSA Bay Networks 37)
- 56 (VSA Bay Networks 38)
- 56 (VSA Bay Networks 39)
- 57 Annex-Tunnel-Id (VSA Bay Networks 40)
- 57 (VSA Bay Networks 41)
- 58 Annex-Callback-Port-List (VSA Bay Networks 42)