Screen Layout
Channel Menu
NEL SELECT button will cause the green selection bar to move from channel to channel.
Left Legend
The legend on the left side of the displayed channel indicates the Channel Number, Voltage Range, AC or
DC Coupling, and where the ground is located. The voltage range indicates the maximum range that will be displayed on the screen.
Message Area
Any messages or warning will be displayed in this area.
Right Legend
The legend on the right side of the displayed channel indicates the Channel Number, the Time base, Trigger type, and trigger level. The time indicated on the screen is the total amount of time displayed. There are
10 divisions on the screen.
Turning Channels on and Off
You can display any combination of 1 to 4 channels on the screen at any time. Use the CHANNEL SELECT Button and the Channel Menu to select the channel you want to turn on. Hold down the CHANNEL SELECT key to activate the channel. If you want to turn a channel off, use the channel select button to select a channel that is on. Hold the CHANNEL SELECT button down to turn the channel off. You cannot turn off all of the channels. At least one channel will be displayed on the screen at all times.
Auxiliary Channel
The auxiliary channel is the 5th selection found in the Channel Menu. To activate the auxiliary channel, use the
CHANNEL SELECT button highlight the Auxiliary Channel. Use the Menu arrow keys to select Lo Amps, Amps, or
Battery Voltage. Press and Hold the CHANNEL SELECT button to turn on the auxiliary channel on. To change what is displayed on the auxiliary channel, turn off the auxiliary channel, use the arrow keys to select a different function, then turn on the display. Only one auxiliary function can be displayed at any one time. If 4 channels are displayed on the screen and you turn on the Auxiliary Channel, the Auxiliary Channel will take the place of channel 4.
www.gxtauto.com
5
Menu
The menu is a way to change the characteristics of the display, any individual channel, or select ignition or the general purpose scope.
When you fi rst press the Menu Button four selections will appear on the screen:
Setup Scope Channel
Setup Display
General - Purpose Scope
Ignition Scope
Use the arrow keys to highlight the selection you want to use, then press the NEXT key to do what you have selected. Pressing the MENU button will return you to the live screen. At any time you can press and hold the
MENU key to return to the live display.
Setup Scope Channel
When this menu function is selected, the following selections will be displayed on the screen:
Channel Number [1]
Coupling (AC/DC) [DC]
Ground Position [MID]
Select Trigger Mode
To make changes using this menu, use the up and down arrow keys to highlight your selection, then press
NEXT to make the change. Pressing the MENU key will cause you to exit this menu and return to the previous menu. When Trigger Mode is selected you will be given a list of trigger types. Use the arrow keys to make your selection, then press the MENU key to return to the previous Menu.
Setup Display
This menu gives you control over the brightness, contrast, and background color for the display. Use the arrow keys to highlight your selection, then press the NEXT key to make your changes. Two different Background colors are supported. The Dark scheme is best for areas with good to poor lighting. The Light scheme is best when outside on a clear day.
General Purpose Scope
When you make this selection you will be returned to the general purpose scope display.
Ignition Scope
This is a preset that will set Channel 1 to use the KV adapter, and activate the low amps auxiliary channel.
6
www.gxtauto.com
