advertisement
Chapter 2 Basic Component Removal Procedures
Blower Control Panel
See Chapter 1 - Drive Components to locate the component detailed in these instructions.
Remove Components
1.
Read and follow the Safety Precautions on page 8 and Important Initial
Steps on page 10 .
2.
Disconnect the three wires (red, white, and blue) at the top of the blower fuse block.
Screws (2) to connect to Stacking Panel
Red White Blue
24
Screws (2) to connect to
Main Control Panel
3.
Label and remove all wiring to TB9.
4.
Remove the two screws that connect the Blower Control Panel to the
Main Control Panel.
NOTE: These screws are already removed if the Main Control Panel has been removed.
5.
Remove the two screws that connect the Blower Control Panel to the
Stacking Panel.
6.
Carefully set the Blower Control Panel aside.
Install Components
1.
When instructed for the component you are replacing, reinstall the Blower
Control Panel in the reverse order of removal.
2.
See page 26 for reinstalling wires to TB9.
3.
Torque panel mounting screws to 2.9 N•m (26 lb•in).
4.
Replace all safety shields and enclosure covers before applying power to the drive.
Rockwell Automation Publication 20B-IN025B-EN-P - January 2011
advertisement
Related manuals
advertisement
Table of contents
- 5 New and Updated Information
- 7 Introduction
- 7 Component Kits
- 8 Recommended Tools
- 9 Safety Precautions
- 10 Important Initial Steps
- 11 Overview
- 16 Circuit Boards
- 17 Fastener Torque Specifications
- 21 Overview
- 22 Main Control Panel
- 24 Blower Control Panel
- 25 Stacking Panel
- 28 Transitional Busbar
- 35 Overview
- 35 Main Control Board
- 38 T-Comm Board
- 40 Power Interface Board
- 43 Switch Mode Power Supply Board
- 45 24V Power Supply Board (for Current Transducers)
- 46 Precharge Board
- 48 DC Bus Filter Board
- 49 Bus Capacitor
- 51 Capacitor Bank Fan
- 52 Balancing Resistor
- 53 Inverter Power Module (IGBT)
- 58 Gate Interface Board
- 60 Current Transducer
- 62 Converter Power Module (SCR) - AC Input Only
- 64 Converter Snubber Resistors - AC Input Only
- 66 Converter Snubber Board - AC Input Only
- 67 Fan Transformer
- 68 Heatsink Fan - Removal from Back of Drive
- 70 Heatsink Fan - Removal from Front of Drive
- 75 Thermal Sensors
- 78 DC Link Choke - AC Input Only
- 79 MOV Surge Suppressor - AC Input Only
- 80 Precharge SCR Module and Diode - DC Input Only