Chapter 4 - Leased Line Operation
F ourW ir e Set up
1. For four-wire leased line operation, connect one of the provided four-wire cables to the LEASED jack on the back of the modem. Connect the other end of the cable to a four-wire leased line jack or terminals supplied by the telephone company.
2. Turn on the modem.
3. Starting at the STATUS screen, press the following buttons on the front panel:
È , Æ , È , È , È , Æ , Æ , Æ , Æ . The SYNC, NORM? screen appears.
4. Press the Enter button to select normal synchronous operation.
5. The OPTION SET screen appears. Press Ç
Å
OPTIONS screen.
Å to exit to the SYNC/ASYNC
6. Press Ç appears.
Å , Ç
Å , Ç
Å , Æ , Æ , Æ , Æ , Æ , Æ . The 4 WIRE LEASE? ORIG screen
7. Choose one of two actions:
• To set up the modem as the originate modem, press the Enter button.
• To set up the modem as the answer modem, press Æ to display the
4 WIRE LEASE? ANSWER screen, and then press the Enter button.
Note: One of the modems in a leased line pair must be configured as the originate modem, and the other as the answer modem, but it does not matter which is which.
8. The OPTION SET screen, or Æ
screen appears. Press
to exit to the
Ç
Å to exit to the ONLINE OPTIONS
CURRENT SETTING= screen.
9. This completes the setup for four-wire leased line operation. Upon completion, the modem attempts to connect to the modem at the other end of the leased line.
If the remote modem has not yet been configured for leased line operation, you may turn off the local modem until the remote one is ready.
Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide (S000276E) 30
