Maintenance. Graco InvisiPac GS35 Plug-Free, 3A2805M, InvisiPac® GS35 Plug-Free™ Hot Melt Applicator
Add to My manuals52 Pages
advertisement
2.
Remove dirty filter (16) from manifold (1).
Material inside the applicator can be near setpoint temperature. Wear protective clothing to avoid severe burns.
Clean hot melt from exterior of gun.
1
Inspect the applicator, fluid lines, cordset, and solenoid cable for wear or damage. See
for instructions.
Remove the filter when the gun is hot. If the gun is cold, the adhesive will be hard and the filter may be difficult to remove or damaged.
1.
Disable gun assembly.
See
Before Beginning Repair, page 19 .
16
Figure 9 Inlet Filter
3.
Apply a thin coating of high-temperature lubricant to seals on the new filter (16) and install in the manifold (1). Torque to 30 in.-lbs (3.4 N∙m), using a 5/32 in. (4 mm) Allen wrench.
Material inside the applicator can be near setpoint temperature. Wear protective clothing to avoid severe burns.
These recommendations are service level guidelines
- actual service levels required in your factory will vary based on environmental and operating conditions. High or low volume adhesive usage, as well as adhesives that contain a powered release agent or are otherwise dusty, will have an impact on the frequency of filter maintenance. To establish a preventative maintenance cycle tailored to your environment, Graco recommends inspecting filters every 4 weeks after installation and replacing when necessary. Document replacement intervals and use this as your preventative maintenance schedule moving forward.
Gun manifold filter
Solenoid exhaust filters
Replace filter every
Replace filter months
Replace filter months
3A2805M 13
advertisement
Related manuals
advertisement
Table of contents
- 3 Warnings
- 5 Approvals
- 6 Models
- 7 Component Identification
- 8 Overview
- 8 Grounding
- 9 Installation
- 9 Mounting
- 9 Connect Heated Hose
- 9 Connect Solenoid Valve
- 10 Connect Triggering Device
- 10 Prime Before Using Equipment
- 11 Flush
- 11 Install Nozzle
- 11 Select RTD
- 12 Operation
- 12 Pressure Relief Procedure
- 13 Maintenance
- 13 Replace Inlet Filter
- 13 Filter Maintenance Guidelines
- 14 Troubleshooting
- 16 Check Module
- 16 Check Nozzle and Module
- 17 Check Heater
- 17 Check RTD
- 18 Check Thermal Cutoff
- 19 Repair
- 19 Before Beginning Repair
- 20 Replace Heater Cartridge
- 20 Replace RTD
- 20 Replace Thermal Cutoff
- 22 Replace Cordset
- 24 Replace Solenoid Valve
- 24 Replace Module
- 24 Replace Applicator
- 25 Notes
- 26 Parts
- 44 Kits and Accessories
- 46 Dimensions
- 50 Technical Data
- 51 Notes
- 52 Graco Extended Warranty