DIN Rear-mount. Pioneer DEH-P9800BT

9

Installation

DIN Rear-mount

Installation using the screw holes on the side of the unit

1. Remove the frame. (Fig. 9)

Frame

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

• It becomes easy to remove the frame if the front panel is released.

2. Fastening the unit to the factory radio mounting bracket.

(Fig. 10) (Fig. 11)

Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5

×

8 mm) or flush surface screws

(5

×

9 mm), depending on the shape of the screw holes in the bracket .

10

Fig. 9

Fig. 10

Fig. 11