Controlling the Projector. wowvision proVEOS

Controlling the Projector

You can send commands to the projector connected to proVEOS to control preprogrammed features directly from the proVEOS software, like powering the projector on or off.

Windows: To show the

Other Sources window, click

Device Control in the main menu.

86 proVEOS User Manual

Mac: Click the

Device Control icon.

To send a command to the projector:

 Select the command to be sent

 Click the

Execute button

Staff can execute any command, while a Participant can only execute the

Power ON and

Power OFF command.

Note: For this feature to work, a serial data cable must be connected between proVEOS and the projector. proVEOS User Manual 87

Controlling from a Mobile Phone

proVEOS can also be controlled from a mobile phone browser connected to the local network. To access the mobile interface:

 Start the mobile browser

 For iPhone, go to: http://<proVEOS IP address>/

 For other mobile browsers, go to: http://<proVEOS IP address>/mobile

Replace

<proVEOS IP address> with the IP address of proVEOS.

The default IP address is

192.168.1.1

.

 Enter your login credentials

On new installations, these default accounts are available:

Staff – user name:

su

/ password:

supass

Participant – user name:

user

/ password:

userpass

Once login is successful, the proVEOS controller is displayed. This is an interface optimized for Safari on the iPhone platform.

88 proVEOS User Manual

The following can be changed from the controller:

 Projector Status : On or Off

 Source Selection : Wireless or Wired

 Projector Volume : Low, Med or High proVEOS User Manual 89