Remote Control . Arrow 3M Network Card, MP180, 3M MP180, MP180 LCoS, MP 180

3M ™ Pocket Projector MP180

Remote Control

(optional accessory)

1 Back

2 Up

3 Zoom

4 Left

5 OK

6 Right

7 Play

8 Down

9 Pause

1

4

7

Using the Remote Control

The remote control (available separately) for the 3M MP180 projector allows you to control most functions of the 3M MP180 projector, such as navigate file list or control video playback. Turn on the projector and wait until the home screen appears and then press any button on the remote control to start using the remote.

The projector will begin projecting the home screen. Now you can control the projector using the remote control.

Important Note: The remote control cannot be used with the web browser, to change machine settings or to enter the pass code.

Remove Protect Film

When the remote control is shipped, the battery and a protective film are installed in the remote control. The protective film must be removed before the remote can be used. Remove the film by pulling it out of the remote control.

2

3

5

6

8

9

© 2011 3M. All Rights Reserved.

27

3M ™ Pocket Projector MP180

Replace the Remote Control Battery

Replace the battery in the remote control with a CR2025 coin cell battery.

1 Turn the remote control over so that bottom (opposite the button) is facing up.

2 Pinch the grooved release toward center of the holder.

3 Pull the holder out.

4 Remove old battery.

5 Insert new battery with "+" facing up.

6 Slide holder into place.

28 © 2011 3M. All Rights Reserved.