Setting the Default IP Address. Jetter JX3-BN-ETH

4 Mounting and Installation

Modifying the IP Address of the Bus Node

Introduction

Replacing a JX3-BN-ETH

Configuration Options

Changing an IP address

To be able to communicate with the bus node JX3-BN-ETH via Ethernet, an unambiguous IP address has to be set on the bus node.

The IP address is stored to the JX3 backplane module. The following configuration data will be preserved:

 IP address of the bus node

 Subnet mask

 IP address of default gateway

 IP address of DNS server

 Bus node name

 Suffix type of the name

 IP port number for JetIP

 JVMDebug

The IP address can be configured in the following ways:

 Default IP address

 Configuration via file "config.ini"

 Configuration via file "config.ini" and DIP switch

 Configuration during runtime via special registers

Step

1

2

3

4

5

Action

Remove power from the bus node JX3-BN-ETH.

Remove the bus node enclosure from the JX3 backplane module.

Make the corresponding DIP switch settings reflecting the IP address.

Reattach the module enclosure to the JX3 backplane module.

Result :

Following restart the bus node JX3-BN-ETH can be reached at the new IP address.

56 Jetter AG