Operating Instruction
9.3 Mounting and dismounting
English
9.3.1. Mounting of pac-Bus
The pac-Bus is an accessory, which facilitates the wiring of the power supply and the common fault signalization.
The components of the pac-Bus type 9194 need to be ordered separately.
Assemble the required number of pac-Bus elements.
Snap the pac-Bus segment on the DIN rail.
Assemble the terminal set at the beginning and the end of the pac-Bus segment.
9.3.2. Mounting / Dismounting on DIN rail with or without pac-Bus
Mounting
Take care that the devices is not canted before it is snapped on the DIN rail.
Put the device on the DIN rail. Take care that the cut out of the enclosure fits onto the edge of the DIN rail.
Swivel the device until it is snapped on the DIN rail.
Dismounting
Pull the latch (1) with the screw driver out.
Swivel the device out.
22
English
9.3.3. Mounting / Dismounting on pac-Carrier
Mounting
Dismount the black and the green terminal. (see chapter
8.3.3)
Single channel device: Dismount the cover of terminal slot 2.
(between black and green terminal)
Operating Instruction
Put the device on the pac-Carrier and swivel the device until the red locking handle is locked.
Please check that the locking handle is locked.
Dismounting
Put the screw driver into the red locking handle (1) and move the screw driver into the described direction.
Device will be moved out of the slot (2).
9.3.4. Mounting / Dismounting detachable terminals
Dismounting
All devices are equipped with detachable terminals.
Place the screw driver between terminal and enclosure.
Move the screw driver as described.
Mounting
Place the terminal into the terminal slot and press it towards the device until it is locked.
23
