Introduction to Module. OSEE DEC6800N

FCC Caution

:

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Introduction to Module

The Front Part of Module

Figure 1-1

DEC/DES6800N

Note: Table 1-1 Introduction to the switch and status LED indicator. Refer to Chapter Three for detailed instructions on switch and status LED indicator.

DEC/DES6800 CVBS/SDI Converter - 2 -

Figure 1-2

Switch and Status LED Indicator on the Front Part of DEC/DES6800

Table 1-2

： Status Indicator and Its Function

CONFIG

(yellow)

POWER

(green)

ERROR

(red)

Off

On

Off

On

Module is in normal operating mode.

Module is initializing or initialized error.

No power to module

Normal operation, module is powered.

WARNING(red)

BANK MARK

(yellow)

Bank 0

BANK MARK1

(yellow) Bank1

625(green)

AUTO(green)

525(green)

GENLOCK(yellow)

On continuously No signal present on input.

Flashing No reference or input signal line rate does not match the reference.

Off

On

Off when module runs in disorder

On/Off combination indicates which bank is selected

(described in Table 3)

Off

On

On continuously Valid 625 video input is present.

Off Standard 625 is not selected or under auto-detection, no valid 625 standard is detected.

Flashing

On

Off

Standard 625 is detected and no valid 625 video input is present.

Auto standard is selected

Auto standard is not selected

On continuously Valid 525 video input is present.

Off Standard 525 is not selected or under auto-detection, no valid 525 standard is detected.

Flashing

Off

On

Standard 525 is selected and no valid 525 video input is present.

Reference genlock mode is not selected

Reference genlock mode is selected

DEC/DES6800 CVBS/SDI Converter - 3 -