1.1 Typical System Installation. CyberData 010860
Add to My manuals44 Pages
CyberData 010860 is a Voice-over-IP (VoIP) Loudspeaker Amplifier that uses a single cable to connect to existing LANs and Session Initiation Protocol (SIP) to broadcast messages over your public address system. Its small footprint and low height make it ideal for discreet mounting. Features include multicast support, SIP compatibility, dual-speed 10/100 Mbps, web-based configuration, PoE (Power-over-Ethernet), and support for 8 ohm Horn speakers.
advertisement
1 Product Overview
The Voice-over-IP (VoIP) Loudspeaker Amplifier (AC powered) uses a single cable to connect to existing LANs, and Session Initiation Protocol (SIP) to broadcast messages over your public address system. The small footprint and low height makes this an ideal loudspeaker amplifier to discreetly mount almost anywhere.
1.1 Typical System Installation
illustrates how the VoIP Loudspeaker Amplifier (AC Powred) is normally installed as part of a public address system.
Figure 1. Public Address System
1 2
Generic PoE Hub
3 4 5 6
1
VoIP Loudspeaker Amplifiers—AC Required
VoIP Phone
Server
VoIP Loudspeaker Amplifier Operations Guide 930111C CyberData Corporation
advertisement
Related manuals
advertisement
Table of contents
- 7 1.1 Typical System Installation
- 8 1.2 Product Features
- 8 1.3 Supported Protocols
- 8 1.4 Supported SIP Servers
- 9 1.5 Product Specifications
- 11 2.1 Parts List
- 12 2.2 Loudspeaker Amplifier Setup
- 12 2.2.1 Loudspeaker Amplifier Components
- 13 2.2.2 Loudspeaker Amplifier Jumpers
- 14 2.2.3 Connect the Loudspeaker Amplifier
- 16 2.2.4 Confirm Operation
- 17 2.2.5 Confirm the IP Address, Test the Audio, and Check the Volume
- 18 2.2.6 Adjust the Volume
- 19 2.3 Configure the Loudspeaker Amplifier Parameters
- 19 2.3.1 Log in to the Configuration Home Page
- 21 2.3.2 Configure the Network Parameters
- 23 2.3.3 Set up the Loudspeaker Amplifier
- 24 2.3.4 Configure the SIP Parameters
- 27 2.4 Set up the MGROUPS
- 29 2.5 Upgrade the Firmware and Reboot the Loudspeaker Amplifier
- 31 2.5.1 Reboot the Loudspeaker Amplifier
- 33 2.6 Restore the Factory Default Settings
- 35 A.1 Mount the Enclosure
- 37 B.1 Set up a TFTP Server
- 37 B.1.1 In a LINUX Environment
- 37 B.1.2 In a Windows Environment
- 39 C.1 Frequently Asked Questions (FAQ)
- 39 C.2 Documentation
- 39 C.3 Contact Information
- 40 C.4 Warranty
- 33 asterisk
- 39 configurable parameters
- 42 gateway
- 42 IP address
- 42 subnet mask
- 42 username and password
- 42 default gateway
- 42 IP address