cNODE Embed Instruction Manual
Kongsberg cNODE Embed
Topics
System description, page 7
System diagram, page 7
Scope of supply, page 8
General supply conditions, page 9
Support information, page 9
6
429468/A
Kongsberg cNODE Embed
System description
The cNODE Embed consists of a printed circuit board and a transducer that integrates into custom pressure housing.
The cNODE Embed provides flexibility to integrate transponder electronics into a custom pressure housing. This reduces the size, weight and the need for subsea interface cabling.
A variety of flush mount and remote transducers are available to provide optimal performance in shallow, deep water or horizontal positioning applications for AUVs,
ROVs, gliders, towed fish or nodes.
It has the same SSBL, LBL and telemetry capability as a standard cNODE and provides the same performance when positioning the transponder with any HiPAP SSBL or cPAP
LBL system.
It operates in the Medium Frequency 20 kHz to 30 kHz band and both FSK and
Kongsberg Cymbal navigation codes are available. Cymbal wide band offers 560 unique navigation codes and range accuracies of better than 2 cm are achievable.
System diagram
The system diagram identifies the main components of the cNODE Embed.
cNODE Embed 33–80V Low
429468/A
7
cNODE Embed Instruction Manual cNODE Embed 33–180 Mini
8
Scope of supply
The following items are provided when you order a cNODE Embed.
cNODE Embed 33–80V Low
• Printed Circuit Board (PCB)
• Transducer TD80V Low
• External capacitors
• Transformer for TD80V
• Cable kit (optional)
• Instruction manual cNODE Embed 33–180 Mini
• Printed Circuit Board (PCB)
• Transducer TD180 Mini
• Transformer for TD180
• Cable kit (optional)
• Instruction manual
429468/A
Kongsberg cNODE Embed
General supply conditions
The following general supply conditions apply to this Kongsberg cNODE Embed delivery.
Receipt, unpacking and storage
Upon accepting shipment of the equipment, the shipyard and/or the dealer must ensure that the delivery is complete and inspect each shipping container for evidence of physical damage.
If the inspection reveals any indication of crushing, dropping, immersion in water or any other form of damage, the recipient should request that a representative from the company used to transport the equipment be present during unpacking.
All equipment must be inspected for physical damage, i.e. broken controls and indicators, dents, scratches etc. during unpacking. If any damage to the equipment is discovered, the recipient must notify both the transportation company and Kongsberg Maritime so that
Kongsberg Maritime can arrange for replacement or repair of the damaged equipment.
Once unpacked, the equipment must be stored in a controlled environment with an atmosphere free of corrosive agents, excessive humidity or temperature extremes.
The equipment must be covered to protect it from dust and other forms of contamination when stored.
Support information
If you need support for your Kongsberg cNODE Embed you must contact Kongsberg
Maritime AS.
• Company name : Kongsberg Maritime AS
• Address : Strandpromenaden 50, 3190 Horten, Norway
• Telephone, 24h support : +47 33 03 24 07
• Telefax : +47 33 04 76 19
• Website : http://www.km.kongsberg.com
• Support website : http://www.km.kongsberg.com/support_hpr
• E-mail address : [email protected]
429468/A
9
