advertisement
radio option, to prevent radio interference, this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada (ICES-003). En cas d’utilisation du module radio 802.11, afin d'éviter toute interférence radio avec le service autorisé, l'appareil doit être utilisé à l'intérieur, tout en tant éloigné de toute fenêtre afin de garantir le maximum de protection. Si cet équipement (ou son antenne émettrice) est installé à l'extérieur, il est alors soumis à licence.
3. Approvals
Safety:
EMC:
Laser:
IEC 60950-1
FCC Part 15 Class B
EN 55022
EN 55024
EN 301 489
IEC 60825-1 2nd edition, Class 1, Class 2
FDA 21 CFR 1040.10
1040.11 Class I, Class II
Bluetooth : 2.0
RF: Bluetooth and 802.11b/g: EN300 328, Part 15.247
4. Safety Summary
4.1 Safety Instructions – AC Adaptors & Docking Stations
SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for chargers.
Important: Use the AC adaptor recommended by Psion Teklogix.
• Before using the charger, read all instructions and cautionary markings on (1) charger, (2) battery and (3) product using battery.
• The mains power cord shall comply with national safety regulations of the country where the equipment is to be sold.
Psion Teklogix 7545 Regulatory & Warranty Guide 7
• Use of an attachment not recommended or sold by Psion Teklogix may result in fire, electric shock, or personal injury.
• To reduce risk of damage to the electric plug and cord when unplugging the charger, pull the plug rather than the cord.
• Make sure the cord is positioned so that it is not stepped on, tripped over, or otherwise subjected to damage or stress.
• Do not operate the charger with a damaged cord or plug. Replace immediately.
• Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; it should be inspected by qualified service personnel.
• Do not disassemble the charger; it should be repaired by qualified service personnel. Incorrect reassembly may result in electric shock or fire.
• To reduce risk of electric shock, unplug the charger from the outlet before attempting any maintenance or cleaning.
• An extension cord should not be used unless absolutely necessary.
Use of an improper extension cord could result in fire or electric shock. If an extension cord must be used, make sure:
- The plug pins on the extension cord are the same number, size, and shape as those on the charger.
- The extension cord is properly wired and in good electrical condition and that the wire size is larger than 16 AWG.
• Do not expose the charger to rain or snow.
• Do not place batteries in the charger if they are cold from extended exposure to a freezer or outside temperatures below 10° C (50° F).
Allow them to warm up to room temperature for at least two hours.
• Do not use the charger if, after an overnight charge, any of the batteries feel warmer than the charger housing. The charger should be inspected by qualified service personnel.
• PX3001 storage temperature is from -30°C to +60°C (-22°F to
140°F). Operating humidity and temperature is 5-95% non-condensing, and 0°C to +40°C (32°F to 104°F).
8 Psion Teklogix 7545 Regulatory & Warranty Guide
advertisement