xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
12
C OMMAND L OGGING C OMMANDS
The command logging function is used to log the commands that have successfully been configured to the switch via the command line interface. The requirement is to log the command itself, along with information about the user account that entered the command into the system log and the informational severity level. Commands that do not cause a change in the switch configuration or operation (such as show) will not be logged. A save command will change the configuration file hence it will be logged. Information about saving or viewing the system log is described in the syslog functional specification and is out of the scope of this UIS.
The Command Logging commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command enable command logging disable command logging show command logging
Parameters
Each command is listed, in detail, in the following sections.
enable command logging
Purpose
Syntax
Description
Parameters
Restrictions
Used to enable command logging. enable command logging
The enable command logging command is used to enable the command logging function.
Note: When the switch is under the booting procedure, all configuration commands will not be logged. When the user has logged in using AAA authentication, the user name should not changed if the user has used the “enable admin” command to replace its privilege.
None.
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable the command logging function:
DGS-3450:admin# enable command logging
Command: enable command logging
Success.
DGS-3450:admin#
disable command logging
Purpose
Syntax
Description
Parameters
Used to disable the command logging function. disable command logging
The disable command logging command is used to disable the command logging function.
None.
94
xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
disable command logging
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To disable the command logging function:
DGS-3450:admin# disable command logging
Command: disable command logging
Success.
DGS-3450:admin#
show command logging
Purpose
Syntax
Description
Parameters
Restrictions
This command displays the switch’s general command logging configuration status show command logging
Use this command to show the command logging configuration status.
None.
Only Administrator and Operator-level users can issue this command.
Example usage:
To show the command logging configuration status:
DGS-3450:admin# show command logging
Command: show command logging
Command Logging State : Disabled
DGS-3450:admin#
95
