advertisement
▼
Scroll to page 2
of 72
Maintenance
Three actions can be selected
“reboot” click the reboot button to restart system
“factory default” Click on Factory default button on the configuration page to restore the factory default settings. Any changes made so far will be lost and the system will be reset to the initial factory settings. The system will restart and require the installer program to set up the network again.
“upgrade firmware” Select the firmware file and click upgrade button
- 46 - www.vivotek.com
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Before You Use This Product
- 7 Package Contents
- 8 Installation
- 8 Hardware installation
- 9 Software installation
- 10 Initial Access to the Network Camera
- 10 Check Network Settings
- 10 Add Password to prevent Unauthorized Access
- 11 How to Use
- 11 Authentication
- 12 Installing plug-in
- 13 Primary user’s capability
- 13 Main Screen with Camera View
- 14 Digital Zoom
- 14 Snapshot
- 15 Client settings
- 18 Administrator’s capability
- 18 Fine-tuning for Best Performance
- 21 Opening accounts for new users
- 22 Build a security application
- 23 Software revision upgrade
- 24 Definitions in Configuration
- 25 System parameters
- 26 Security settings
- 27 Network settings
- 27 Network type
- 28 RTSP Streaming
- 30 WLAN Configuration
- 34 Access List
- 35 Audio and Video
- 35 General
- 35 Video Settings
- 35 Video orientation
- 36 Audio settings
- 37 Image Settings
- 38 Email & FTP
- 38 Email
- 40 Motion detection
- 41 Application settings
- 41 Snapshot
- 41 Weekly schedule
- 41 Snapshot file name prefix
- 41 Send out the snapshot while motion detection
- 42 Sequential operation
- 42 Method for sending snapshot
- 45 System log
- 46 Viewing system parameters
- 47 Maintenance
- 48 Appendix
- 48 A. Troubleshooting
- 48 Status LED
- 48 Reset and restore
- 49 B. URL commands of the Network Camera
- 49 Get server parameter values
- 50 Set server parameter values
- 52 Available parameters on the server
- 63 Application page CGI command
- 65 Capture single snapshot
- 66 Account management
- 67 System logs