6. Attach the Left Press Arm. Precor S3.55

S3.55 Assembly and Maintenance Guide

6. Attach the Left Press Arm

Important: For ease of assembly, lower the Seat

Back Frame by pressing the Release Bar on the

Left Seat Handlebar.

A. Place the Cables protruding from the end of the

Left Press Arm over the Press Arm Flange.

B. Carefully lower the Left Press Arm into the Press

Arm Bracket while keeping the Axle Tube level.

C. Secure the Left Press Arm using two 1-inch bolts (blue patch) two lockwashers two washers

Wrench tighten.

Important: In Step C, slide a lockwasher on the bolt. Follow it with a flat washer.

Note: During both assembly and disassembly, you will need to insert a metric hex key into the access hole at the top of the Axle Tube to remove the two ¾-inch bolts. The metric hex key keeps the fasteners from spinning.

A

Press Arm Flange

Cables Left Press Arm

C

2 - 1" bolts

2 - lockwashers

2 - washers

Axle Tube

Axle Tube

B

Press

Arm

Bracket

Lockwasher

Flat Washer

Left

Press

Arm

Seat Back

Frame

Step 6. Attach the Left Press Arm

1 2 3 4 5 6 page 14