1. Lat Pull and Seated Row Cable (46007-102) Adjustment. Precor S3.55

S3.55 Assembly and Maintenance Guide

1. Lat Pull and Seated Row

Cable (46007-102) Adjustment

A. When the S3.55 assembly is complete, check that the Cam Washer rests against the welded triangle as shown. If slack exists in the cable, continue with step B.

B. To remove slack, use a

⁹⁄₁₆

-inch wrench and loosen the nut on the opposite side of the bolt and Cam

Washer. With another

⁹⁄₁₆

-inch wrench turn the

Cam Washer either direction, so the bulk of the washer moves toward the welded triangle. When the Cable slack is removed, re-tighten the fasteners.

Important: Make sure the cable is not over tightened. If it is, a gap appears between the rubber bumper of the Double Pulley Block and the

Crossbar.

Center Support

Bracket

A

Cam Washer

Center Support

Bracket

B

Cam Washer

1 2

Step 2. Lat Pull and Seated Row Cable (46007-102) Adjustment

3 4 5 6 page 55