Connecting Push/Pull Gun. Miller MATIC 355, MILLERMATIC 355

5-21. Connecting Push/Pull Gun

3/32 in.

(2.4 mm) allen_wrench allen_set

2 3

NGO’s tools/ flathead philips head wrench crescent wrench pliers needlenose knife steelbrush nutdriver chippinghammer solderiron stripcrimp heavy-duty workclamp light-duty workclamp wirecutter frontcutter

5 4

1 torque screwdriver torque wrench socket wrench drill strapwrench airgun hammer handream awl greasegun filterwrench file

OM-288360A Page 34 paintbrush qtip (swab) vicegrip crimper feelergauge flashlight ruler toothbrush punch solvent pinextractor eprompuller pipewrench

OM-222 Page 1

Obtain gas cylinder and chain to running gear, wall, or other stationary support so cylinder cannot fall and break off valve.

1 Gun End

2 Gun Liner

3 Wire Outlet Guide

Trim excess liner from end of gun so no more than 3/32 in. (2.4 mm) of liner extends past wire outlet guide.

4 Gun Securing Knob

Loosen securing knob. Insert gun end through opening until it bottoms against drive assembly (make sure gun end does not touch drive rolls). Tighten knob.

Be sure to change drive rolls to the proper size and type.

5 10 Pin Gun Trigger Plug

Insert plug into receptacle, and tighten threaded collar.