Turn the Pump On and Off. Baxter Auto Syringe AS50

Detailed Instructions

6.

Grasp the FINGER GRIP (1) on the DRIVER (2) and pull it all the way out. Slide the

DRIVER down until it contacts the syringe plunger, then release.

7.

Push the PLUNGER CLAMP in firmly to capture the syringe plunger.

2

1

ON/OFF

SWITCH

Turn the Pump On and Off

The ON/OFF switch is on the left side of the pump, near the bottom. Turn the pump on by sliding the switch up to the ON position.

Note: If the syringe is improperly mounted, the pump displays one of the following alert messages: CHECK BARREL , CHECK FLANGE , or CHECK PLUNGER . Examine the syringe and correct the indicated problem. If a combination of conditions is sensed, the pump displays a CHECK SYRINGE alert or alarm message instead.

The pump is turned off by sliding the switch down to the OFF position.

Page 30 Auto Syringe AS50 Infusion Pump Operator’s Manual 07-19-B3-430