Camera. Apple iPhone iPhone SE 3rd Generation
Add to My manuals79 Pages
Apple iPhone SE 3rd Generation boasts an advanced camera system with a 12MP rear camera and a 7MP front-facing camera, allowing you to capture stunning photos and videos. The device's A15 Bionic chip delivers powerful performance for gaming, streaming, and multitasking. With a long-lasting battery, you can enjoy hours of use without worrying about running out of power. Additionally, the iPhone SE 3rd Generation features a durable design with a water-resistant construction, making it suitable for everyday use.
advertisement
iPhone SE (3rd generation)
Camera
Before You Begin
Camera | Before You Begin
Warning
Read
Battery Safety and follow workspace and battery handling guidelines before you begin.
Remove the following part before you begin:
•
Tools
• ESD-safe tweezers
• JCIS bit
• Nitrile or lint-free gloves
• Nylon probe (black stick)
• Super screw bit
• Torque driver (green, 0.45 kgf cm)
© 2022 Apple Inc. All rights reserved. 073-00333-A | 41
iPhone SE (3rd generation)
Removal
1. Use a torque driver and the JCIS bit to remove the crosshead screw from the camera cowling. Set aside the screw.
2. Use a torque driver and the super screw bit to remove the super screw from the camera cowling. Set aside the super screw.
3. Remove the camera cowling and save it for reassembly.
Camera | Removal
© 2022 Apple Inc. All rights reserved. 073-00333-A | 42
iPhone SE (3rd generation)
4. Use the flat end of the black stick to lift the end of the camera flex cable off the connector.
5. Remove the camera from the enclosure.
Camera | Removal
© 2022 Apple Inc. All rights reserved. 073-00333-A | 43
iPhone SE (3rd generation) Camera | Reassembly
Reassembly
1. Put on the gloves to prevent contamination of the camera lens. Then hold the replacement camera with the lens facedown and remove the protective cover from the camera lens.
2. Rest the camera in the enclosure. Don’t press the camera into the enclosure yet.
3. Press the end of the camera flex cable to the connector (1).
Gently press the camera into the enclosure (2).
© 2022 Apple Inc. All rights reserved. 073-00333-A | 44
iPhone SE (3rd generation)
4. Position the camera cowling on the camera.
5. Use the green torque driver and super screw bit to partially install one new super screw into the camera cowling. Don’t fully tighten the super screw yet.
Camera | Reassembly
© 2022 Apple Inc. All rights reserved. 073-00333-A | 45
iPhone SE (3rd generation)
6. Use the green torque driver and JCIS bit to partially install one new crosshead screw into the camera cowling.
7. Fully torque the two screws into the camera cowling.
Reinstall the following part to complete reassembly:
•
Camera | Reassembly
© 2022 Apple Inc. All rights reserved. 073-00333-A | 46
advertisement
Related manuals
advertisement
Table of contents
- 2 Contents
- 3 Introduction
- 6 Internal View
- 7 Orderable Parts
- 8 Screws
- 9 Tools
- 12 Battery Safety
- 15 Broken Glass
- 17 First Steps
- 18 SIM Tray
- 19 Display
- 20 Removal
- 31 Reassembly
- 41 Camera
- 42 Removal
- 44 Reassembly
- 47 Taptic Engine
- 48 Removal
- 54 Reassembly
- 60 Battery
- 61 Removal
- 66 Reassembly
- 71 Speaker
- 72 Removal
- 75 Reassembly