Installation. Furrion 14 cu.ft Built-in Four Door Refrigerator

5

Installation

This appliance is intended to be used in household and similar applications such as:

– Staff kitchen areas in shops, offices and other working environments.

– Farm houses and by clients in hotels, motels and other residential type environments.

– Bed and breakfast type environments.

– Catering and similar non-retail applications.

This refrigerator is not approved for use as a free standing refrigerator. Incorrect installation, adjustment, alteration or maintenance of this refrigerator can cause personal injury, property damage or both. Obey the instructions in this manual to install the refrigerator.

Do not install the refrigerator directly on carpet. Put the refrigerator on a metal or wood panel that extends the full width and depth of the refrigerator.

Do not allow anything to touch the refrigerator cooling system.

Make sure the electrical installation obeys all applicable codes. Do not bypass or change the refrigerator’s electrical components or features.

What’s in the Box

Make sure you have the following listed items included in the packaging. If any item is damaged or missing, contact your dealer.

● Refrigerator

● Instruction Manual

● Warranty Card

● Ice Tray

Install the Refrigerator

CAUTION: Do not lift or drag the refrigerator doors during installing, damage to the refrigerator can result. Furrion recommends you have another person to assist during installation process.

1. Select a suitable position where you are going to install your refrigerator.

2. Mark and cut out an open area on the wall according to the dimensions outlined in Fig. 1.

B

C

A

Fig. 1

Item

A

B

C

72 1/4 " (1835mm)

31

22

3/4 " (806mm)

13/16

Dimension

" (580mm) min.

D 73 1/4 " (1860.5mm) min.

3. Drill a 11/2” hole on the vehicle wall using a hole saw. (Fig.

2) Extend the power cord from the to cutting hole and connect to the refrigerator (see “Electrical Connection” section for detail) CAUTION: Ensure there are no electrical cables, gas lines, pipes or other important parts behind the wall where the drill holes will be.

1 1 / 2 "

35.0 mm

Fig. 2

4. Pull on the top of the exhaust vent towards you and lift to remove it from the refrigerator. (Fig. 3 and Fig. 4) Pull on both left and right sides to remove the bottom intake vent from the refrigerator. (Fig. 5)

115⁄16”

50mm min.

Fig. 3

Fig. 7

6. Fix the refrigerator into the enclosure through the mounting flange using 9 self-tapping screws (ST 4.8 *19).

(Fig. 8 and Fig. 9)

Fig. 4

Fig. 8

Fig. 5

5. Put the refrigerator completely into the enclosure. (Fig.

6) Make sure to leave 1 15/16 ” (50mm) minimum space from the back of the refrigerator to the cabinet for better air circulation. (Fig. 7)

Fig. 9

7. Open the bottom doors of the refrigerator and secure the refrigerator into the enclosure using two self-tapping screws. (Fig. 10)

Fig. 6

Fig. 10

6