Unpacking. Kobold Pad, PAD-...N

PAD

3.1 Unpacking

When moving the transmitter to the installation site, transfer it in its original packaging. Only unpack the transmitter on site of installation to avoid damage during transit.

3.2 Models and Specifications Check

The model’s name and specifications are indicated on the top name plate fixed to the transmitters. Please check your specification and model supplied for your installation.

3.3 Storage

The following precautions must be observed when storing the instrument, especially for a long period.

(1) Select a storage area that meets the following conditions:

(a) It is not directly exposed to rain, water, snow or sun light.

(b) It is exposed to minimum vibration and shock.

(c) If possible, it is advisable to store at normal temperature and humidity

(approx. 25 °C, 65 % RH).

However, it can also be stored under ambient temperature and relative humidity within the following published ranges.

Ambient Temperature: -40 ~ 80 °C (with LCD module) *

* General use only. For explosion proof versions follow product certification requirements.

Relative Humidity: 5 % ~ 98 % RH (at 40 °C)

(2) When storing the transmitter, repack with original (or similar) packaging that was shipped from the factory.

(3) If storing a transmitter that has already been used, thoroughly clean all wetted parts including diaphragm seals (if installed), process connections/manifolds in contact with process fluid. In addition, make sure before storing the transmitter that remote seal (if supplied) assemblies are securely mounted. page 12 PAD K15/0522 ATEX