Wiring Harness. Can-Am Spyder Trailer RT

MAINTENANCE PROCEDURES

2. Remove bolts and nuts securing position light to trailer body.

3. Unplug both connectors.

rmo2013-007-004_a

1. Position light connectors

4. Pull out the position light.

5. Insert wires of the new position light through the trailer body hole.

6. Connect the connectors (match color).

7. Secure the light on trailer body with previously removed bolts and nuts.

8. Tighten nuts to the specified torque.

TIGHTENING TORQUE

Position light nuts

5 N•m ± 0.5 N•m

(44 lbf• in ± 4 lbf• in )

9. Reinstall inner fascias. Refer to

NER FASCIA

in this section.

IN-

License Plate Light Replacement

1. Remove the lens screws with a

Phillips head screwdriver.

rmo2010-005-049_a

1. License plate light

2. License plate lens screws

2. Pull out the lens.

3. Remove the bulb by pulling it out.

4. Install the new bulb by pushing it in.

5. Reinstall the lens.

Wiring Harness

Wiring Harness Inspection

Check trailer harness and connector for damages. Repair or replace as required.

Wiring and Connector Identification

When making wiring or connector repairs on trailer connector, refer to illustration below to identify the appropriate and necessary connections.

WH

BR

2 1 2 1

3 4

3 4

GN

YL rmo2013-007-025_a

1. WH=WHITE (ground)

2. BR=BROWN (position lights/tail light)

3. YL=YELLOW (RH brake/turn signal)

4. GN=GREEN (LH brake/turn signal)

28

______________