AC-to-USB Adapter. Zebra ZQ300

Charging the Battery

When the battery is first installed, the printer power and charge indicators should indicate the battery is not fully charged (see

“Charging the Battery” below and “Operator Controls”).

Important • You must charge the battery fully before using the printer for the first time.

AC-to-USB Adapter

Use Case: Home Office/Small Business

Figure 6 • AC-to-USB Adapter

AC Adapter

USB

Connector

USB Type-C

Connector

Rubber Door

• Connect the USB connector to the AC Adapter.

• Plug the AC Adapter into an AC receptacle.

• Rotate the rubber door on the printer counterclockwise to expose the USB port.

• Plug the USB Type-C end of the cable into the USB port on the printer. The connector will plug into the port in either direction as it is not keyed.

• The printer will power up and begin charging. The printer can be left on or turned off at this point as charging will continue in either state.

Important • While it’s possible to charge the battery when using the printer, charge times will increase under this condition.

Note • See Appendix B for LED Charging Behavior.

17

ZQ300 Series User Guide