advertisement
Parameter
Max TMDS Clock Frequency
Max video resolution supported
HDCP Pass-Through
IR Extension
RS-232 Extension
10/100Mbps Ethernet Pass-Through
Fallback to 100BaseTx, IEEE 802.3u
USB Over Centre Tap
Power Over Ethernet
Audio
LEDs - HD Base Status
Value
270 MHz
4096x2160 @30Hz
Yes, from Source to Projector
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Not Supported
Operation: Green, Left
Link/Mode: Yellow, Right
3.1.3 Control Interfaces
The HDBaseT input can also be used as a regular network port. See
“Connector Specifications”, page 28
, HDBaseT specification.
HDBaseT as network input
About
The following control interfaces are available on the projector:
• 1x RS-232 (for projector control)
• 1x LAN/Ethernet (for projector control
• 2x USB-A ports
3.1.3.1 RS-232
Specifications
Parameter
RS-232 connector
Value
1 female DB9 connector (RS232-in) for projector control and debug
3.1.3.2 LAN/Ethernet
Specifications
Parameter
Ethernet connector
Protocols
Speed
Value
1 RJ45 Connector for projector control (not content)
DHCP, TCP/IP, UDP/P
10/100 Mbit/1000Mbit
30 R5911698 /04 Bragi
advertisement
Related manuals
advertisement
Table of contents
- 7 1 Safety
- 8 General considerations
- 8 Important safety instructions
- 11 Safety symbols Bragi
- 12 Location of labels
- 13 2 Getting to know the projector
- 14 Location of the main exterior components
- 15 Service and maintenance
- 15 Power on / Standby button backlight indications
- 15 LCD Panel
- 15 LCD panel general
- 16 LCD touch panel
- 16 LCD Status screens
- 18 OSD Menu mode
- 18 LCD functionality in Ready Mode
- 18 Local keypad
- 19 Shortcut buttons
- 20 Remote control
- 20 Remote control, battery installation
- 21 Remote control, protocol setup
- 22 Functionality overview
- 23 Remote control, on/off button
- 23 Function of the RGB filter button
- 23 Enable / Disable Remote Control
- 24 Wired RC connection
- 24 Projector Address
- 25 Controlling the projector
- 25 Connector panel
- 27 3 Getting the projector started
- 28 Projector source and control connections
- 28 Input source connections
- 28 Connector Specifications
- 28 Specifications DVI-I inputs
- 28 Display Port
- 29 Specifications HDMI
- 29 Specifications HDBase T input
- 30 Control Interfaces
- 30 LAN/Ethernet
- 31 USB-A port
- 31 Power up the projector
- 31 Power down the projector
- 32 Power mode transitions
- 32 General
- 32 Power on projector
- 32 Going from READY to ON
- 33 Going from ON to READY
- 33 Going from READY to ECO standby
- 33 Going from ECO to ON
- 33 Wake On LAN (WOL)
- 33 Power modes
- 33 Customize projector settings
- 34 User interface
- 34 On Screen Display (OSD)
- 37 4 GUI – Profiles
- 38 Profiles introduction
- 38 Profiles setup parameters
- 39 Saving settings to a new profile
- 41 Deleting a projector profile
- 43 5 Upgrade projector firmware
- 44 Upgrade procedure
- 45 6 User maintenance — Cleaning the projector
- 46 Projector lenses
- 46 Projector cabinet
- 47 A Regulatory information
- 48 Product compliance
- 49 Turkey RoHS compliance
- 49 China RoHS compliance
- 50 Taiwan RoHS compliance
- 51 Contact information
- 52 Production address
- 52 Product Info
- 52 Disposal Information
- 53 Disposal of batteries
- 55 Index
- 51 Location of the main exterior components
- 52 Service and maintenance
- 52 Power on / Standby button backlight indications
- 52 LCD Panel
- 55 Local keypad
- 56 Shortcut buttons
- 57 Remote control
- 55 Projector Address
- 55 Connector panel
- 52 Projector source and control connections
- 55 Power up the projector
- 55 Power down the projector
- 56 Power mode transitions
- 57 Power modes
- 57 Customize projector settings
- 58 User interface