Introduction to configuration and commissioning
October 2022
Configuration and Use Manual
MMI-20019053
3.2 Default values and ranges
See Default values and ranges to view the default values and ranges for the most commonly used parameters.
3.3 Enable access to the off-line menu of the display
Display
ProLink III
Field Communicator
OFF-LINE MAINT → OFF-LINE CONFG → DISPLAY
Device Tools → Configuration → Transmitter Display → Display Security
Configure → Manual Setup → Display → Offline Variable Menu Features
By default, access to the off-line menu of the display is enabled. If it is disabled, you must enable it if you want to use the display to configure the transmitter.
Restriction
You cannot use the display to enable access to the off-line menu. You must make a connection from another tool.
3.4 Disable write-protection on the transmitter configuration
Display
ProLink III
OFF-LINE MAINT → CONFG → LOCK
Device Tools → Configuration → Write-Protection
If the transmitter is write-protected, the configuration is locked and you must unlock it before you can change any configuration parameters. By default, the transmitter is not write-protected.
Tip
Write-protecting the transmitter prevents accidental changes to configuration. It does not prevent normal operational use. You can always disable write-protection, perform any required configuration changes, then re-enable write-protection.
3.5 Restore the factory configuration
Display
ProLink III
Field communicator
Not available
Device Tools → Configuration Transfer → Restore Factory Configuration
Service Tools → Maintenance → Reset/Restore → Restore Factory Configuration
Restoring the factory configuration returns the transmitter to the same configuration it had when it left the factory. This may be useful if you experience problems during configuration.
Important
You cannot restore factory configurations with a 700 core.
Tip
Restoring the factory configuration is not a common action. You may want to contact customer support to see if there is a preferred method to resolve any issues.
18 Micro Motion 2700 Transmitters with Configurable Input/Outputs
