A7600E-H Hardware Design V1.02
8
Appendix
8.1
Coding Schemes and Maximum Net Data Rates over Air Interface
Table 47: Coding Schemes and Maximum Net Data Rates over Air Interface
Multislot definition(GPRS/EDGE)
Slot class DL slot number UL slot number Active slot number
3
4
1
2
5
6
7
8
9
10
11
12
2
3
1
2
2
3
3
4
4
4
3
4
2
1
1
1
2
2
3
2
3
1
2
4
3
4
2
3
4
4
4
5
5
5
5
5
GPRS coding scheme
CS 1 = 9.05 kb/s / time slot
CS 2 = 13.4 kb/s / time slot
CS 3 = 15.6 kb/s / time slot
CS 4 = 21.4 kb/s / time slot
Max data rata （ 4 slots ）
36.2 kb/s
53.6 kb/s
62.4 kb/s
85.6 kb/s
Modulation type
GMSK
GMSK
GMSK
GMSK
EDGE coding scheme
MCS 1 = 8.8 kb/s/ time slot
MCS 2 = 11.2 kb/s/ time slot
MCS 3 = 14.8 kb/s/ time slot
MCS 4 = 17.6 kb/s/ time slot
MCS 5 = 22.4 kb/s/ time slot
MCS 6 = 29.6 kb/s/ time slot
MCS 7 = 44.8 kb/s/ time slot
MCS 8 = 54.4 kb/s/ time slot
MCS 9 = 59.2 kb/s/ time slot
HSDPA device category
Max data rata （ 4 slots ）
35.2 kb/s
44.8 kb/s
59.2 kb/s
70.4 kb/s
89.6 kb/s
118.4 kb/s
179.2 kb/s
217.6 kb/s
236.8 kb/s
Max data rate(peak)
Modulation type
GMSK
GMSK
GMSK
GMSK
8PSK
8PSK
8PSK
8PSK
8PSK
Modulation type www.simcom.com
65/70
Category 1
Category 2
Category 3
Category 4
Category 5
Category 6
Category 7
Category 8
Category 9
Category 10
Category 11
Category 12
Category 13
Category 14
Category 15
Category 16
Category 17
Category 18
Category 19
Category 20
Category 21
Category 22
Category 23
Category 24
HSUPA device category
Category 1
Category 2
Category 3
Category 4
Category 5
Category 6
LTE-FDD device category
(Uplink)
Category 1
Category 2
Category 3
Category 4
1.2Mbps
1.2Mbps
1.8Mbps
1.8Mbps
3.6Mbps
3.6Mbps
7.2Mbps
7.2Mbps
10.2Mbps
14.4Mbps
0.9Mbps
1.8Mbps
17.6Mbps
21.1Mbps
23.4Mbps
28Mbps
23.4Mbps
28Mbps
35.5Mbps
42Mbps
23.4Mbps
28Mbps
35.5Mbps
42.2Mbps
Max data rate(peak)
0.96Mbps
1.92Mbps
1.92Mbps
3.84Mbps
3.84Mbps
5.76Mbps
Max data rate （ peak ）
5Mbps
25Mbps
50Mbps
50Mbps
A7600E-H Hardware Design V1.02
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
16QAM,QPSK
64QAM
64QAM
64QAM
16QAM
16QAM
64QAM
64QAM
16QAM,QPSK
QPSK
QPSK
64QAM
64QAM
16QAM
16QAM
64QAM
Modulation type
QPSK
QPSK
QPSK
QPSK
QPSK
QPSK
Modulation type
QPSK/16QAM
QPSK/16QAM
QPSK/16QAM
QPSK/16QAM www.simcom.com
66/70
A7600E-H Hardware Design V1.02
8.2
Related Documents
Table 48: Related Documents
[3]
[4]
NO. Title
[1]
[2]
A7600 Series AT Command
Manual _V1.00.04
ITU-T Draft recommendationV.25ter
new
GSM 07.07
GSM 07.10
[5]
[6]
[7]
[8]
[9]
GSM 07.05
GSM 11.14
GSM 11.11
GSM 03.38
GSM 11.10
[10] 3GPP TS 51.010-1
[11] 3GPP TS 34.124
[12] 3GPP TS 34.121
[13] 3GPP TS 34.123-1
[14] 3GPP TS 34.123-3
[15] EN 301 908-02 V2.2.1
Description
AT Command Manual
Serial asynchronous automatic dialing and control
Digital cellular telecommunications (Phase 2+); AT command set for GSM Mobile Equipment (ME)
Support GSM 07.10 multiplexing protocol
Digital cellular telecommunications (Phase 2+); Use of Data
Terminal Equipment – Data Circuit terminating Equipment
(DTE – DCE) interface for Short Message Service (SMS) and
Cell Broadcast Service (CBS)
Digital cellular telecommunications system (Phase 2+);
Specification of the SIM Application Toolkit for the Subscriber
Identity Module – Mobile Equipment (SIM – ME) interface
Digital cellular telecommunications system (Phase 2+);
Specification of the Subscriber Identity Module – Mobile
Equipment (SIM – ME) interface
Digital cellular telecommunications system (Phase 2+);
Alphabets and language-specific information
Digital cellular telecommunications system (Phase 2) ；
Mobile Station (MS) conformance specification ； Part 1:
Conformance specification
Digital cellular telecommunications system (Release 5);
Mobile Station (MS) conformance specification
Electromagnetic Compatibility (EMC) for mobile terminals and ancillary equipment.
Electromagnetic Compatibility (EMC) for mobile terminals and ancillary equipment.
Technical Specification Group Radio Access Network;
Terminal conformance specification; Radio transmission and reception (FDD)
User Equipment (UE) conformance specification; Part 3:
Abstract Test Suites.
Electromagnetic compatibility and Radio spectrum Matters
(ERM); Base Stations (BS) and User Equipment (UE) for
IMT-2000. Third Generation cellular networks; Part 2:
Harmonized EN for IMT-2000, CDMA Direct Spread
(UTRA FDD) (UE) covering essential requirements of article
3.2 of the R&TTE Directive www.simcom.com
67/70
A7600E-H Hardware Design V1.02
[16]
[17]
[18]
[19]
[20]
EN 301 489-24 V1.2.1
IEC/EN60950-1(2001)
3GPP TS 51.010-1
GCF-CC V3.23.1
2002/95/EC
Electromagnetic compatibility and Radio Spectrum Matters
(ERM); Electromagnetic Compatibility (EMC) standard for radio equipment and services; Part 24: Specific conditions for
IMT-2000 CDMA Direct Spread (UTRA) for Mobile and portable (UE) radio and ancillary equipment
Safety of information technology equipment (2000)
Digital cellular telecommunications system (Release 5);
Mobile Station (MS) conformance specification
Global Certification Forum - Certification Criteria
Directive of the European Parliament and of the Council of 27
January 2003 on the restriction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS)
Module secondary SMT Guidelines [21] Module secondary-SMT-UGD-V1.xx
[22] Antenna design guidelines for diversity receiver system
[23] A7600 Series_UIM HOT
SWAP_Application
Note_V1.00
Antenna design guidelines for diversity receiver system
This document introduces UIM card detection and UIM hot swap.
8.3
Terms and Abbreviations
Table 49: Terms and Abbreviations
Abbreviation Description
ADC Analog-to-Digital Converter
AMR
CS
CSD
CTS
DTE
DTR
DTX
EFR
EGSM
ESD
ETS
FR
GPRS
Adaptive Multi-Rate
Coding Scheme
Circuit Switched Data
Clear to Send
Data Terminal Equipment (typically computer, terminal, printer)
Data Terminal Ready
Discontinuous Transmission
Enhanced Full Rate
Enhanced GSM
Electrostatic Discharge
European Telecommunication Standard
Full Rate
General Packet Radio Service www.simcom.com
68/70
A7600E-H Hardware Design V1.02
FD
LD
MC
ON
RC
SM
NC
RX
SIM
SMS
TE
TX
UART
URC
PCB
PCL
PCS
PDU
PPP
RF
RMS
RTC
GSM
HR
IMEI
Li-ion
MO
MS
MT
PAP
PBCCH
Global Standard for Mobile Communications
Half Rate
International Mobile Equipment Identity
Lithium-Ion
Mobile Originated
Mobile Station (GSM engine), also referred to as TE
Mobile Terminated
Password Authentication Protocol
Packet Broadcast Control Channel
Printed Circuit Board
Power Control Level
Personal Communication System, also referred to as GSM 1900
Protocol Data Unit
Point-to-point protocol
Radio Frequency
Root Mean Square (value)
Real Time Clock
Receive Direction
Subscriber Identification Module
Short Message Service
Terminal Equipment, also referred to as DTE
Transmit Direction
Universal Asynchronous Receiver & Transmitter
Unsolicited Result Code
USSD
PB abbreviation
Unstructured Supplementary Service Data
SIM fix dialing phonebook
SIM last dialing phonebook (list of numbers most recently dialed)
Mobile Equipment list of unanswered MT calls (missed calls)
SIM (or ME) own numbers (MSISDNs) list
Mobile Equipment list of received calls
SIM phonebook
Not connect
8.4
Safety Caution
Table 50: Safety Caution www.simcom.com
69/70
Marks
A7600E-H Hardware Design V1.02
Requirements
When in a hospital or other health care facility, observe the restrictions about the use of mobiles. Switch the cellular terminal or mobile off, medical equipment may be sensitive and not operate normally due to RF energy interference.
Switch off the cellular terminal or mobile before boarding an aircraft. Make sure it is switched off. The operation of wireless appliances in an aircraft is forbidden to prevent interference with communication systems. Forgetting to think much of these instructions may impact the flight safety, or offend local legal action, or both.
Do not operate the cellular terminal or mobile in the presence of flammable gases or fumes. Switch off the cellular terminal when you are near petrol stations, fuel depots, chemical plants or where blasting operations are in progress. Operation of any electrical equipment in potentially explosive atmospheres can constitute a safety hazard.
Your cellular terminal or mobile receives and transmits radio frequency energy while switched on. RF interference can occur if it is used close to TV sets, radios, computers or other electric equipment.
Road safety comes first! Do not use a hand-held cellular terminal or mobile when driving a vehicle, unless it is securely mounted in a holder for hands free operation.
Before making a call with a hand-held terminal or mobile, park the vehicle.
GSM cellular terminals or mobiles operate over radio frequency signals and cellular networks and cannot be guaranteed to connect in all conditions, especially with a mobile fee or an invalid SIM card. While you are in this condition and need emergent help, please remember to use emergency calls. In order to make or receive calls, the cellular terminal or mobile must be switched on and in a service area with adequate cellular signal strength.
Some networks do not allow for emergency call if certain network services or phone features are in use (e.g. lock functions, fixed dialing etc.). You may have to deactivate those features before you can make an emergency call.
Also, some networks require that a valid SIM card be properly inserted in the cellular terminal or mobile.
www.simcom.com
70/70
