__________________________________________________________________________________________
2.1
Hardware Description
To use XTEL-CAD, the following software configuration is required:
• OS/2, Version 1.2, 1.3 or 2.1,
• X-TEL (TXT L BASE V5) or MINI X-TEL (TXT L BJR V5) Software Workshop,
• PL7-3 programming software.
This implies using a hardware configuration that meets the requirements described below:
• FTX 507 terminal:
- 6 MBytes RAM recommended,
- 40 MByte hard disk.
• An IBM PS/2 or PC compatible micro-computer comprising:
- A CPU comprising an 80286 or later microprocessor (80386 recommended),
- 6 Mbytes RAM recommended,
- 40 Mbytes hard disk,
- A high resolution EGA or VGA monitor,
- The appropriate national or international keyboard.
The XTEL-CAD software package, ref. TXT L CAD V5E, comprising:
• A 3 1/2" program diskette (TXT LF CAD V5),
• A software protection key module,
• This documentation, ref. TXT DM CAD V5E.
Documentation
†
Software Key Diskette
XTEL-CAD
Reference Manual
G
X-TEL
Software Workshop
To insert in the X-TEL documentation
†
†
__________________________________________________________________________________________
2 / 2
