Storing Your Machine

For more helpful maintenance tips, check out support.BISSELL.com

.

Once your cleaning is complete, make sure both the Dirty and Clean Water Tanks are emptied, rinsed out and dried before the next use. Store cleaner in a protected, dry area.

Troubleshooting

Below are some of the issues you may run into. If you don’t see the issue you’re experiencing below, visit support.BISSELL.com

.

Problem

Reduced or no spray

Possible Cause

Clean Water Tank may be empty.

Tank may not be seated completely.

Pump may have lost prime.

DirtLifter®

PowerBrush does not turn

Cleaner not picking up solution

Remedies

Fill Clean Water Tank with hot tap water.

Turn power OFF. Remove and reseat tank.

Turn power OFF and then back ON. Wait one minute, then press trigger.

Turn power OFF. Use hand to remove debris.

Debris filter on base is clogged.

The belt is off or broken.

The machine is in the upright position.

Circuit breaker on machine may have tripped.

Tanks may not be seated properly.

Clean Water Tank is empty.

Turn power OFF and unplug machine from outlet. Follow instructions on page 8.

Brushes only rotate when machine is reclined using the recline handle.

Turn the machine OFF and unplug from outlet.

Check to see if foreign object is caught in Brush

Roll. Remove object. Plug machine in to reset circuit breaker.

Turn the machine OFF. Pick up both the Clean and Dirty Water Tanks and reseat them so they fit snuggly on the machine.

Check fluid levels in Clean Water Tank and refill if necessary.

Empty Dirty Water Tank.

Dirty Water Tank has picked up the maximum amount.

Red float “door” in the tank may have closed as a result of bumping an object or moving machine back and forth too quickly.

Front nozzle of machine is clogged.

Upper body filter is clogged.

Turn the machine OFF, allowing red float door to release into the open position. Turn the machine back ON to continue cleaning. Be sure your forward and backward strokes are completed at a slower pace.

Turn the machine OFF. Use fingers to remove any debris from this area.

Turn the machine OFF. Use fingers to remove any debris from this area.

NOTICE

To reduce the risk of a leaking condition, do not store unit where freezing may occur. Damage to internal components may result.

WARNING

To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.

10 BISSELL.com

We’re Waggin’ Our Tails!

BISSELL® proudly supports BISSELL Pet Foundation® and its mission to help save homeless pets. When you buy a BISSELL product, you help save pets, too. We’re proud to design products that help make pet messes, odors and pet homelessness disappear.

Visit BISSELLsavespets.com

to learn more.

But wait, there’s more!

Join us online for a complete guide to your new product, including troubleshooting, product registration, parts, and more.

Go to support.BISSELL.com.

REGISTER INFO VIDEOS PARTS SUPPORT

©2020 BISSELL Inc. All rights reserved.

Part Number 1624684 04/20 RevF