Connections to your TV. JVC DR-MV99B, DR-MV99BU

14

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the ANTENNA OUT jack on the Recorder to the antenna in jack on the TV using the supplied 75ohm Coaxial Cable (R).

How to set the Recorder’s RF output channel

1. When the Recorder is turned off, press and hold

CH (-/+) on the front panel for more than five seconds. [RF03] or [RF04] appears in the display window.

2. Press CH (-/+) to change the RF output channel

(RF03 or RF04).

3. Tune the TV to this channel.

Notes:

• Set the resolution to 480p using OUTPUT STATUS button on the front panel for progressive signal.

• Progressive Scan does not work with the RF, Video or

S-Video connections.

• If your TV does not accept the Progressive Scan format, the picture will appear scrambled.

• If the resolution is set to 720p or 1080i, the VIDEO

OUTPUT, S-VIDEO OUTPUT and COMPONENT OUT-

PUT connections are not available.

Audio connection

Connect the Left and Right AUDIO OUTPUT jacks on the Recorder to the audio left/right in jacks on the TV using the supplied audio cables (A1 or A2).

Rear of TV

S-VIDEO

INPUT

COMPONENT/PROGRESSIVE SCAN

VIDEO INPUT

Pr Pb Y

AUDIO INPUT

R L

Video connection

Connect the VIDEO OUTPUT jack on the Recorder to the video in jack on the TV using the video cable supplied (V).

Note:

If you use this connection, set the TV’s source selector to

VIDEO.

S-Video connection

Connect the S-VIDEO OUTPUT jack on the Recorder to the S-Video in jack on the TV using the optional

S-Video cable (S).

Component Video connection

If your television is a high-definition or “digital ready” television, you may take advantage of the Recorder’s progressive scan output for the highest video resolution possible.

Connect the COMPONENT OUTPUT jacks on the

Recorder to the corresponding in jacks on the TV using an optional Y P

B

P

R cable (C).

Rear of Recorder

R

S

Rear of TV

C A2

V A1