Connection to an Amplifier. JVC DR-MV99B, DR-MV99BU

16

Connection to an Amplifier

Connecting to an amplifier equipped with two channel analog stereo or Dolby Pro Logic II/Pro

Logic

Connect the Left and Right AUDIO OUTPUT jacks on the Recorder to the audio left and right in jacks on your amplifier, receiver, or stereo system using the audio cables (A) supplied.

Connecting to an amplifier equipped with two channel digital stereo (PCM) or to an Audio/Video receiver equipped with a multi-channel decoder (Dolby

Digital™, MPEG 2, or DTS)

1. Connect one of the Recorder’s DIGITAL AUDIO

OUTPUT jacks (OPTICAL O, COAXIAL X) to the corresponding in jack on your amplifier. Use an optional digital (optical O, coaxial X) audio cable.

2. You will need to activate the Recorder ’s digital output. (See [Audio Settings] on page 22).

Digital Multi-channel sound

A digital multi-channel connection provides the best sound quality. For this you need a multi-channel

Audio/Video receiver that supports one or more of the audio formats supported by your Recorder (MPEG 2,

Dolby Digital and DTS). Check the receiver manual and the logos on the front of the receiver.

Caution:

Due to the DTS Licensing agreement, the digital output will be in DTS digital out when DTS audio stream is selected.

Notes:

• If the audio format of the digital output does not match the capabilities of your receiver, the receiver will produce a strong, distorted sound or no sound at all.

• Six Channel Digital Surround Sound via digital connection can only be obtained if your receiver is equipped with a Digital Multi-channel decoder.

• To see the audio format of the current DVD in the onscreen display, press AUDIO.

• This Recorder does not perform internal (2 channel) decoding of a DTS sound track. To enjoy DTS multi channel surround, you must connect this Recorder to a

DTS compatible receiver via one of this Recorder’s digital audio outputs.

• While viewing a digital channel, the 2 channel stereo audio is only output through the audio output jacks.

O

Rear of Recorder

X A

OPTICAL

DIGITAL INPUT

COAXIAL

DIGITAL INPUT

L R

AUDIO INPUT

Amplifier (Receiver)

Manufactured under license from Dolby

Laboratories. “Dolby”, “Pro Logic”, and the double-D symbol are trademarks of Dolby

Laboratories.

“DTS” and “DTS Digital Out” are registered trademarks of DTS, Inc.