Configuring an SRv6 SID. Aruba FlexNetwork MSR958X_2003X Routers Comware 9 Segment Routing, S0P11A, S0W31A

पीडीएफ

दस्तावेज़

2. Configuring route exchange between a PE and a CE

Configure an IPv4 routing protocol (static routing, RIP, OSPF, IS-IS, EBGP, or IBGP) or an IPv6 routing protocol (IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, EBGP, or IBGP) to exchange routes between a PE and a CE

On the CE, configure an IPv4 or IPv6 routing protocol to advertise routes of the local site to the

PE. On the PE, associate the routing protocol with the VPN instance. For more information about routing protocol configurations, see Layer 3—IP Routing Configuration Guide .

3. Configuring route exchange between PEs a.

Configuring an SRv6 SID

Perform this task to manually configure an End.DT4, End.DT6, End.DT46, End.DX4, or

End.DX6 SID. b.

Applying a locator to a BGP VPN instance

BGP can advertise SRv6 SIDs through BGP routes only after you apply a locator to BGP. c.

Configuring SRv6-encapsulated EVPN route advertisement

Perform this task to advertise VPN routes as EVPN routes to a peer or peer group in the

EVPN L3VPN over SRv6 network. d. Configuring PEs to exchange BGP EVPN routes e.

(Optional.) Configuring next hop-based dynamic End.DX4 or End.DX6 SID allocation for

BGP routes

This feature enables a PE to dynamically allocate End.DX4 or End.DX6 SIDs to BGP private network routes based on the route next hops. f.

(Optional.) Configuring BGP EVPN route settings

Configuring the route recursion mode

5. Specifying a source address for the outer IPv6 header of SRv6-encapsulated EVPN L3VPN packets

This feature specifies the source address of the outer IPv6 header for SRv6 packets forwarded between two private network sites over the backbone network.

(Optional.) Configuring EVPN L3VPN over SRv6 FRR

(Optional.) Configuring a TTL processing mode for tunnels associated with a VPN instance