advertisement
4.0 OPERATION
Once the CopperLink-T T1/E1 Extenders are properly installed, they should operate transparently. No user settings required. This section describes reading the LED status monitors.
4.1 FRONT PANEL LED STATUS MONITORS
Models 2113 and 2115 feature three front-panel LEDs that monitor power,
Ethernet signals, and the CopperLink connection. Figure 5 shows the front panel location of each LED. Table 1 describes the LED functions.
CopperLink™-T
T1/E1 Link Extender
LED
Power
Link
Frame
Link
Frame
Po w e r
Frame
LED
Link
LED
Power
LED
Figure 5. CopperLink-T T1/E1 Extender front panel
Table 1: Front panel LED description
Description
•
•
•
When lit, indicates the unit is powered on
On solid—link is connected
Off—No signal detected
Flashing — Data is being transmitted/received
•
•
• On solid—T1/E1 frame is connected
Off — No signal detected
Flashing — Error detected
13
advertisement
Related manuals
advertisement
Table of contents
- 3 Warranty Information
- 3 Radio and TV Interference
- 3 CE Declaration of Conformity
- 4 Authorized European Representative
- 4 FCC Part
- 4 Industry Canada Notice
- 6 Compliance
- 6 Safety
- 6 PSTN Regulatory
- 6 Service
- 7 (EMEA)
- 7 Safety When Working With Electricity
- 8 General Information
- 8 Features
- 8 Description
- 9 Installation
- 10 Connecting Power
- 10 Power Input Connector
- 10 External AC universal power supply
- 11 Connecting the Line Port
- 11 Connecting the Circuit Interface
- 13 Operation
- 13 Front Panel LED Status Monitors
- 14 Configuration and Dip Switches
- 14 Switch S1-7: Line Build Out
- 15 Specifications
- 15 Circuit Rates
- 15 Circuit Interface
- 15 Circuit Defaults
- 15 Circuit Connector
- 15 LED Indicators
- 15 Power and Power Supply Specifications
- 16 Environmental
- 16 Transmission Line
- 16 Line Coding
- 16 A.10 Line Interface
- 16 A.11 Line Physical Connection
- 17 Factory Default Dip Switch Configuration
- 17 Switch S1 - Factory Default configuration
- 17 Switch S2 - Factory Default configuration