3.3 Additional Information Page. Black Box AV200

Adapter Configuration

3.3 Additional Information Page

This page shows more detailed information about the adapter.

System Information

Uptime

Firmware Version

Shows how long the adapter has been running since the last startup.

Shows the detailed firmware version.

MAC Status

MAC Address

MAC Type

Node Type

Network Identifier

Encryption Key

Displays the unique hardware address

(serial number) of the adapter.

This should be In-Home AV.

Shows the type of device – this can be EP, AP or Static AP. For more information about these types, please see section 3.4.3.1.

Shows the Network Identifier. Only devices with the same Network

Identifier can communicate with each other.

Shows whether or not the network encryption is enabled.

11

Network Status

IP Configuration

IP Address

Subnet Mask

Default Gateway IP Address

Shows “Fixed” for set static IP addresses, or “DHCP” if the device receives an address from the server.

Shows the current IP Address of the adapter.

Shows the subnet mask.

Shows the Default Gateway.

Corinex AV200 CableLAN Adapter

Adapter Configuration

PHY Status

Notches

Power Control

Indicates whether or not frequency notches are enabled. notches should always be enabled, in order to eliminate interference with Radio Amateur bands specified by the local authorities.

Indicates status of the power control mechanism (described in chapter

3.4.4).

Multicast Status

IGMP Aware Multicast Syndication

Multicast Bindings

Shows the status of the IGMP settings

(described in chapter 3.4.5).

Shows all multicast bindings between multicast IP Addresses and AV200

CableLAN MAC addresses.

12

VLAN Status

VLAN Configuration

VLAN Tag

VLAN Priority

Indicates whether or not VLAN (virtual networking) is enabled.

Shows the selected VLAN Tag. All traffic from the ethernet port carries this tag.

Shows the selected priority, which is inserted into the VLAN tag.

Corinex AV200 CableLAN Adapter

Priority Status

Default Priority

Criterion 1 & 2

Security Status

Status

Adapter Configuration

Shows the default priority for traffic transmission.

Shows which criteria are used to classify traffic. This can be TOS, 802.1p or

Custom. If Custom, the complete parameters are displayed below.

Please see chapter 3.4.7 for additional information.

Indicates whether or not the configuration page is password protected.

13

Corinex AV200 CableLAN Adapter