Clock and Calendar. Oregon BAR908HG, BAR908HGU, BAR908HGA

next to the Area. Then, simultaneously press and hold MEM and CHANNEL for 2 seconds.

NOTE

If the sensor is still not found, check the batteries.

CLOCK AND CALENDAR

This product tracks the time and date based on radiocontrolled signals from the RTGN318 / RTGN318D /

RTGN318A remote sensor, or manual settings that you enter.

RADIO-CONTROLLED CLOCK

The time and date are automatically updated by radiocontrolled clock signals from official time-keeping organizations. The signals are collected by the remote sensor RTGN318 / RTGN318D / RTGN318A.

• BAR908HG (RTGN318):

DCF-77 signal: within 1500 km (932 miles) of Frankfurt,

Germany.

• BAR908HGU (RTGN318D):

Slide EU / UK to select the signal received.

EU: DCF-77 signal: within 1500 km (932 miles) of Frankfurt,

Germany.

UK: MSF-60 signal: within 1500 km (932 miles) of Anthorn,

England.

• BAR908HGA (RTGN318A):

WWVB-60 signal: within 3200 km (2000 miles) of Fort

Collins,Colorado.

Initial reception takes 2-10 minutes, and is initiated when you first set up the unit, and whenever you press RESET.

11

Once complete, the reception icon will stop blinking.

The

2 factors:

icon shown in the Clock Area indicates

• Connection between the main unit and the sensor that collects RF signals ( )

• RF signal reception (

)

How these signals work together:

ICON MEANING

The unit has contact with the sensor and has synchronized the time.

The unit has contact with the sensor but the time has not been synchronized.

The unit has lost contact with the remote sensor but the time is synchronized.

The unit has lost contact with the remote sensor and the time is not synchronized.

The unit cannot reach the remote sensor.