TRoUblEshooTINg pRoblEM
Line will not advance when using the auto-feed head:
possIblE CAUsE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
solUTIoN
Lubricate with silicone spray.
Install more line. Refer to
line Replacement
earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to
line Replacement earlier in this manual.
Grass wraps around boom housing and line head
Motor fails to start when switch trigger is depressed.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
Cut tall grass from the top down to prevent wrapping.
To secure the battery pack, make sure the latches on each side of the battery pack snap into place.
Charge the battery pack according to the instructions included with your model.
CALL US FIRST
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your product has been fully tested prior to shipment to ensure your complete satisfaction.
10 — English
