2.3 First Scan. Opticum HD T90, Dekoder STB-HD T90, Dekoder STB

8

Installation

2

Read this chapter to learn how to connect the receiver to a TV set, configure the receiver, use USB drive and more.

2.1 Connection

1

1 2 3

3

4

1

2

•

•

•

•

Connect an antenna to receiver’s AERIAL IN connector.

Using HDMI cable connect the receiver with flat panel TV or

Using SCART cable connect it with classic TV.

At the end connect the main cord to the main socket.

4

2.2 Starting up for the first time

Turn on the TV Set. After a while on TV Set you should see receiver’s OSD.

If the TV Set is not displaying receiver’s OSD, probably a signal source is set wrong. Check the TV Set documentation for information how to change the signal source.

Generally once the receiver is switched on, the Welcome Screen emerges. To enter Installation Guide menu use OK button on the remote control or wait few seconds.

1/5 Select language

2/5 Choose tv and aspect

Using / buttons choose menu language. Confirm your choice using blue button on remote control.

Using / buttons choose TV and aspect mode. Choose 4:3 for standard TV or 16:9 for flat panel TV (LCD,LED). You can also choose option that your TV will manage aspect recognition (SCART connection is required). Confirm your choice using blue button on remote control.

3/5 Select menu style and color

Using / buttons choose menu color.

Confirm your choice using blue button on remote control.

4/5 Select summer time

Using / buttons choose if you want to select summer time. It is important for proper working of EPG (Electronic Program Guide). Confirm your choice using blue button on remote control.

5/5 Select country

Using / buttons choose a country where you will receive terrestrial TV signal. Confirm your choice using blue button on remote control.

If you want to return to previous level in this Guide, use red button.

If after switching on the receiver, you cannot see the Installation Guide menu, use MENU button to enter the main menu and using / buttons choose TOOLS menu and select Load Factory Settings and confirm it using

OK button (default password is 0000).

Installation

9