advertisement
CadJet T-200 Service Manual
Symptoms
Table 4-1. Troubleshooting Table (cont).
Possible cause Solution
Internal ERROR
“MPCB Failure”
• bad MPWA replace MPWA
Unrecognized
Cartridges Error
• faulty connection check cartridges of cartridge ID chip to flex cable
• wrong cartridges check cartridges installed
• carriage flex check flex driver cable disconnected cable connections
• trailing cable connections
• faulty trailing cable reseat trailing cable replace trailing cable
• MB version incorrect
• faulty carriage
PWA verify correct MB version (ie 18-27-0) replace carriage
PWA
Image Skews or
Moves
• dirty encoder strip clean encoder strip (top and bottom)
• defective encoder replace encoder strip strip
Troubleshooting 4-6
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 18 Related Publications
- 29 Microprocessor
- 29 Gate Array
- 30 Memory Circuits
- 30 Flash EEPROM
- 31 DRAM
- 31 Serial EEPROM
- 32 Stepper Motor Controller
- 34 Servo Motor Controller
- 36 Control Panel
- 37 Interface Circuits: Parallel
- 42 Cleaning Procedures
- 42 External Cleaning
- 42 Slide Shaft Cleaning
- 43 Service Station Cleaning
- 44 Linear Encoder Strip Cleaning
- 45 Cartridge Dimples Cleaning
- 46 Flex Cable Contact Cleaning
- 47 Clean and Inspect Stepper Motor Gears
- 47 Clean and Inspect MPWA
- 48 Clean and Inspect Carriage Assembly
- 48 Reseat Connectors on MPWA and Carriage Board
- 51 Replace Carriage Bushings
- 55 Common Banding Causes
- 57 Slide Shaft Profile Adjustment
- 60 Head Height Alignment Procedure
- 64 Paper Skew Adjustment
- 64 Paper Skew Adjustment Sequence
- 65 Mounting Screw Information
- 68 Other Functional Requirements
- 69 Adjustment of Pinch Roller Supports
- 69 Visual Verification
- 70 Observation of Paper Skew at Rear Media Alignment Mark
- 71 Observation of Paper Skew at Front Media Alignment Mark
- 72 Adjustment of the Mounting Screws
- 73 Paper Axis Calibration
- 75 Deadband Alignments
- 76 Color Deadband Alignment
- 78 Color Calibration
- 87 No Power
- 88 Initialization Failure
- 88 Media Does Not Move
- 89 Internal ERROR “Carriage Axis Failure”
- 91 Internal ERROR “Encoder Sensor Failure”
- 91 Internal ERROR “Paper Sensor Failure”
- 92 Internal ERROR “MPCB Failure”
- 92 Unrecognized Cartridges Error
- 92 Image Skews or Moves
- 93 Does Not Print
- 93 Ink Cartridge Misfiring
- 95 Paper Skewing
- 95 Printer Output is Banding (Horizontal)
- 97 Printer Output is Banding (Vertical)
- 98 Printer Output is Banding (Horizontally and Vertically)
- 98 Keypad Locked- Up or Not Functioning Properly
- 99 Noisy Operation
- 100 Line Quality Degraded
- 101 Fan Does Not Power Up
- 101 Media is Not Measured Properly