advertisement
Introduction
Identification numbers
There are type plates on the engine and transmission, marked with identification numbers. This information must always be used as reference when service and spare parts are ordered. You will probably find similar plates on your boat and its equipment. Note this information below, make a copy of the page and store it in a safe place, so that you can have the information available if the boat is stolen.
The appearance and location of the type plates is shown below. The figures in brackets refer to the location of the identification number on the type plate.
Engine
Product number (1)
Produkt designatinon (2) .................................................................................................
Engine number (3) ...........................................................................................................
Reverse gear
Product designation (6) ..................................................................................................
Serial number (7) .............................................................................................................
Product number (8) .........................................................................................................
THIS ENGINE TYPE IS CERTIFIED
ACC. TO IMO NOx TECHNICAL CODE
ANNEX VI
Certification decal
Warranty decal
10
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 12 Identification number
- 13 Presentation
- 13 Technical description
- 14 Orientation
- 17 Instruments
- 17 Instruments
- 17 Ignition lock
- 17 Start/stop panel
- 18 Alarm display
- 21 EVC control panel
- 23 Controls
- 23 Single lever control
- 25 Starting the engine
- 25 Before starting
- 25 General information about starting
- 26 Starting method
- 28 Operation
- 28 Reading instruments
- 29 Cruising speed
- 29 Synchronising engine speed
- 30 Changing the control position
- 31 Operation
- 32 Propeller shaft brake
- 32 Stopping the engine
- 33 Cold weather precautions
- 33 Laying up
- 34 In case of emergency
- 34 Starting with auxiliary batteries
- 35 Emergency shifting
- 36 Fault-tracing
- 37 Diagnostic function
- 38 Reading fault codes
- 39 Erasing fault codes
- 40 Maintenance schedule
- 42 Maintenance
- 42 Engine, general
- 45 Lubrication system
- 48 Freshwater system
- 53 Seawater system
- 58 Fuel system
- 63 Electrical system
- 68 Reverse gear
- 70 Laying up/Launching
- 70 Inhibiting
- 71 Bringing out of storage
- 72 Fault code register
- 80 Technical data
- 80 Engine
- 82 Reverse gear