advertisement
In case of emergency
Despite regular maintenance according to the maintenance schedule and perfect operation, it may occur that a fault occurs which must be attended to before the boat can travel further. This chapter contains tips for rectifying some of the possible faults.
There are safety functions which are activated when certain faults occur, to protect the engine. The following can occur:
●
●
●
Engine can not be started
Reversing gear in neutral and engine speed is limited to 1000-1200 rpm, depending on engine.
The engine stops
Flash out any fault codes and take the recommended measures. Please refer to the “Diagnostic function” and
“Fault codes” chapters.
Starting with auxiliary batteries
WARNING! Ventilate well. Batteries contain and give off an explosive gas which is highly flammable and explosive. A short circuit, open flame or spark could cause a violent explosion.
WARNING! Never confuse the positive and negative poles on the batteries. Risk of arcing and explosion.
1. Check that the rated voltage of the help start battery is the same as the system voltage of the engine.
2. Connect the red jumper cable to the positive pole
(+) of the flat battery, and then to the positive pole of the help start battery.
3. Connect the black jumper cable to the negative
pole (–) of the help start battery, and then to a place some distance from the flat batteries, such as the negative connection on the starter motor.
WARNING! Under no circumstances may the black jumper cable (–) come into contact with the positive connection on the starter motor.
4.
Start the engine and run at a fast idle for about ten minutes to charge the batteries.
WARNING! Working with, or going close to a running engine is a safety risk. Watch out for rotating components and hot surfaces.
WARNING! Do not touch the connections during the start attempt: Risk of arcing. Do not stand bending over any of the batteries either.
5. Stop the engine. Remove the jumper cables in the exact reverse order from installation.
32
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 12 Identification number
- 13 Presentation
- 13 Technical description
- 14 Orientation
- 17 Instruments
- 17 Instruments
- 17 Ignition lock
- 17 Start/stop panel
- 18 Alarm display
- 21 EVC control panel
- 23 Controls
- 23 Single lever control
- 25 Starting the engine
- 25 Before starting
- 25 General information about starting
- 26 Starting method
- 28 Operation
- 28 Reading instruments
- 29 Cruising speed
- 29 Synchronising engine speed
- 30 Changing the control position
- 31 Operation
- 32 Propeller shaft brake
- 32 Stopping the engine
- 33 Cold weather precautions
- 33 Laying up
- 34 In case of emergency
- 34 Starting with auxiliary batteries
- 35 Emergency shifting
- 36 Fault-tracing
- 37 Diagnostic function
- 38 Reading fault codes
- 39 Erasing fault codes
- 40 Maintenance schedule
- 42 Maintenance
- 42 Engine, general
- 45 Lubrication system
- 48 Freshwater system
- 53 Seawater system
- 58 Fuel system
- 63 Electrical system
- 68 Reverse gear
- 70 Laying up/Launching
- 70 Inhibiting
- 71 Bringing out of storage
- 72 Fault code register
- 80 Technical data
- 80 Engine
- 82 Reverse gear