Specifications. Rockford Fosgate Power T500-1bdCP, Power T500-1bd, Power T1500-1bdCP, Power T1000-1bd, Power T1500-1bd, Power T1000-1bdCP, Power T1500-1bd CP, Power T500-1bd CP, t 500 1 bd, Power T1000-1bd CP


Add to My manuals
52 Pages

advertisement

Specifications. Rockford Fosgate Power T500-1bdCP, Power T500-1bd, Power T1500-1bdCP, Power T1000-1bd, Power T1500-1bd, Power T1000-1bdCP, Power T1500-1bd CP, Power T500-1bd CP, t 500 1 bd, Power T1000-1bd CP | Manualzz

S

PECIFICATIONS

MODEL- POWER

4 Load Mono

2 Load Mono

1 Load Mono

T500-1bd CP

300 Watts x 1

500 Watts x 1

500 Watts x 1

T1000-1bd CP

Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts

Dimensions: Height

Width

Length

2.14" (5.42cm)

8.14" (20.68cm)

11.41" (28.97cm)

700 Watts x 1

1,000 Watts x 1

1,000 Watts x 1

2.14" (5.42cm)

8.14" (20.68cm)

13.66" (34.69cm)

T1500-1bd CP

1,000 Watts x 1

1,500 Watts x 1

1,500 Watts x 1

2.14" (5.42cm)

8.14" (20.68cm)

14.91" (37.86cm)

Battery Fuse Rating (Amp) External

(Not Supplied)

100A 150A 200A

“A” Weighted Signal to Noise Ratio

Referenced to 1 Watt into 4 ohms

“A” Weighted Signal to Noise Ratio

Referenced to rated output into 4 ohms

Crossover Slope

Crossover Frequency

Frequency Response

Signal Voltage Adjustment Range

Protection

Equalization PEQ (Punch Equalization)

Input Impedance

Infrasonic Filter

Operating Voltage

Balanced Inputs

CMRR (Common Mode Rejection Ratio)

Damping Factor

THD+N (Total Harmonic Distortion + Noise) (T500-1bd CP)

THD+N (Total Harmonic Distortion + Noise) (T1000-1bd CP)

THD+N (Total Harmonic Distortion + Noise) (T1500-1bd CP)

≥80 dB

≥100 dB

24dB/octave Butterworth variable from 35Hz to 250Hz

20Hz to 250Hz ±0.5dB

Variable from 150mV to 5V (RCA Input)

Short circuit protection shut downs the amplifier in case of very low impedance or shorted speaker wires.

Thermal switch shuts down the amplifier in case of overheating.

Variable from 0dB to +18dB @ 45Hz

20K ohms

Selectable 12dB/Octave, -3dB @ 28Hz

9 to 16 Volts DC

Yes

>55dB @ 1KHz

>200

< 0.5% @ 1 ohm

< 0.7% @ 1 ohm

< 0.8% @ 1 ohm

These specifications are Amplifier Power Standard CEA-2006 Compliant

Specifications subject to change without notice

10

advertisement

Key Features

  • Variable low-pass filter for precise subwoofer control
  • Adjustable gain for matching with different source units
  • Infrasonic filter to eliminate unwanted low frequencies
  • Compact design for easy installation in tight spaces
  • High-current output for powering demanding subwoofers
  • Built-in protection circuits for reliable operation

Related manuals

Frequently Answers and Questions

What is the power output of the Power T500-1bd?
The Power T500-1bd delivers 500 watts RMS of power to a single subwoofer.
What is the frequency response of the Power T500-1bd?
The frequency response of the Power T500-1bd is 20Hz to 200Hz.
What is the recommended impedance for the Power T500-1bd?
The recommended impedance for the Power T500-1bd is 2 ohms.
What type of subwoofer can I use with the Power T500-1bd?
The Power T500-1bd is designed to power a single subwoofer with an impedance of 2 ohms.
What is the warranty period for the Power T500-1bd?
The Power T500-1bd is covered by a 1-year limited warranty.

advertisement

Table of contents