Electrical General VN from 2/98 and VHD

Group 3 Electrical System, VN & VHD Service Procedures

3935-03-02-01

TV Speaker/Headphone Jack, Replacement

You must read and understand the precautions and guidelines in Service Information, group 30, "General

Safety Practices" before performing this procedure.

If you are not properly trained and certified in this procedure, ask your supervisor for training before you perform it.

Removal

1

Turn the ignition key

OFF. Turn off the power to the TV.

2

Remove the six screws from the sleeper control panel.

Pull the panel cover away from the bunk wall.

3

Disconnect the TV speaker and harness connector.

Sleeper Control Panel, Rear View

1 Speaker Mounting Screws

2 TV Speaker Connector

3 TV Harness Connector

4 TV Jack

W3004368

4

Remove the two mounting screws for the TV speaker.

Remove the TV speaker.

5

To remove the TV speaker jack, remove the nut on the front with a 1/2 inch socket and remove the jack.

Installation

1

Install the replacement TV speaker into the control panel with the two mounting screws.

139

Group 3 Electrical System, VN & VHD Service Procedures

2

Install the replacement speaker jack and secure the nut with a 1/2 inch socket.

3

Connect the connectors.

4

Turn on power to the TV. Check the speaker for operation.

5

Insert the sleeper control panel into the trim panel. Install the six mounting screws.

140