- No category
advertisement
Preliminary User's Manual l TQMLS102xA UM 0002 l © 2015 TQ-Group Page 5
2.1 Key functions and characteristics
The TQMLS102xA provides the following key functions and characteristics:
Graphics
SD card interface
On-Board flash (NOR, eMMC, NAND)
DDR3L SDRAM
USB 2.0 Hi-Speed interface with PHY
USB 3.0 Hi-Speed interface with PHY
Ethernet 10/100/1000
CAN
SATA
PCIe
I²C, I²S, SPI, UART
RTC (optional)
Software support possible for: o
Linux o
VxWorks o
QNX o
PikeOS
All essential CPU pins are routed to the connectors.
There are therefore no restrictions for customers using the TQMLS102xA with respect to an integrated customised design.
2.2 Available versions
The default versions offer the following basic features:
CPUs: LS1020, LS1021, LS1022
DDR3/4L-RAM:
QSPI NOR flash:
EEPROM:
1 Gbyte + ECC
512 Mbyte
64 kbit
All versions of the TQMLS102xA are fully pin-compatible and therefore interchangeable.
The functionality of the different TQMLS102xA is mainly determined by the features provided by the respective CPU.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 6 About this manual
- 6 Copyright and licence expenses
- 6 Registered trademarks
- 6 Disclaimer
- 6 Imprint
- 7 Tips on safety
- 7 Symbols and typographic conventions
- 7 Handling and ESD tips
- 8 Naming of signals
- 8 Further applicable documents / presumed knowledge
- 9 Brief description
- 10 Key functions and characteristics
- 10 Available versions
- 11 Electronics Specification
- 11 System overview
- 11 System architecture / block diagram
- 12 System components
- 12 CPU LS102xA
- 12 CPU versions
- 16 Boot options
- 18 Multiplexing
- 19 Pinout connectors
- 21 JTAG interface
- 22 Deep Sleep
- 22 DDR3L SDRAM
- 23 On-board flash
- 23 Reset structure
- 24 Housekeeping
- 24 Overview
- 26 Temperature supervision
- 28 EEPROM
- 28 Power supply
- 28 Power estimation
- 28 External interfaces
- 28 SERDES
- 29 Mechanics
- 29 Connectors
- 29 TQMLS102xA image
- 30 Adaptation to the environment
- 30 Protection against external effects
- 30 Thermal management
- 30 Structural requirements
- 30 Notes of treatment
- 31 Technical data
- 31 Vibration load
- 31 Shock load
- 31 Software
- 32 Safety requirements and protective regulations
- 33 Operational safety and personal security
- 33 Climatic and operational conditions
- 33 Reliability and service life
- 33 Environment protection
- 33 REACH
- 34 Battery
- 34 Other entries
- 35 Appendix
- 35 Acronyms and definitions
- 36 References