multimess User manual Technical parameters 1D4

KBR multimess 1D4

5.1.1 Commi function

With the "commi" start-up function, up to 10 measuring modules connected can be integrated.

This includes: Password protection for configuration

Assigning names to individual measuring modules

Scan menu for reading in measuring modules connected

Removing measuring modules connected

Selection of single-phase or 3-phase measurements

Configuration of current transformer primary / secondary

Configuration of voltage transformer primary / secondary

5.1.3 Para function

With the "para" configuration function, you can display the firmware version of the measuring modules connected, change the LCD settings and choose between English and German as the display language.

5.1.4 Consumption monitoring

In this operating mode, momentary measured values as well as continuous meters for active and reactive energy consumption can be read out directly at the display.

22 V1.00

V1.00

KBR multimess 1D4

The respective module name is included on each screen, depending on the measuring module selected.

The following momentary values can be displayed:

1 st

screen: Voltage Ph-N for phase L1, L2 and L3 individually

2 nd screen: Voltage Ph-Ph for phase L1-2,

L2-3 and L3-1 individually

3 rd screen: Apparent current for phase

L1, L2 and L3 individually

4 th

screen: Total power for apparent, active and reactive power

5 th screen: Apparent power for phase

L1, L2 and L3 individually

6 th

screen: Active power for phase

L1, L2 and L3 individually

7 th

screen: Reactive power for phase

L1, L2 and L3 individually

8 th screen: Cosine Phi for phase

L1, L2 and L3 individually

9 th screen: Power frequency

10 th screen: Continuous energy meter for active energy consumption

Continuous energy meter for reactive energy consumption

11 th screen: Commissioning

(Extras menu)

LCD parameters

23